lkml.org 
[lkml]   [2019]   [Apr]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v2] mmc: core: Verify SD bus width
Date
> 
> The SD Physical Layer Spec says the following: Since the SD Memory Card
> shall support at least the two bus modes 1-bit or 4-bit width, then any SD
> Card shall set at least bits 0 and 2 (SD_BUS_WIDTH="0101").
>
> This change verifies the card has specified a bus width.
>
> AMD SDHC Device 7806 can get into a bad state after a card disconnect
> where anything transferred via the DATA lines will always result in a
> zero filled buffer. Currently the driver will continue without error if
> the HC is in this condition. A block device will be created, but reading
> from it will result in a zero buffer. This makes it seem like the SD
> device has been erased, when in actuality the data is never getting
> copied from the DATA lines to the data buffer.
>
> SCR is the first command in the SD initialization sequence that uses the
> DATA lines. By checking that the response was invalid, we can abort
> mounting the card.
>
> Acked-by: Avri Altman <avri.altman@wdc.com>
>
> Signed-off-by: Raul E Rangel <rrangel@chromium.org>
Reviewed-by: Avri Altman <avri.altman@wdc.com>

Thanks,
Avri

\
 
 \ /
  Last update: 2019-04-18 08:20    [W:0.306 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site