lkml.org 
[lkml]   [2019]   [Mar]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v2 03/10] powerpc/6xx: Store PGDIR physical address in a SPRG
On Thu, Mar 07, 2019 at 06:14:09PM +0000, Christophe Leroy wrote:
> Hi,
>
> On 03/07/2019 02:11 PM, Guenter Roeck wrote:
> >Hi,
> >
> >On Thu, Feb 21, 2019 at 10:37:55AM +0000, Christophe Leroy wrote:
> >>Use SPRN_SPRG2 to store the current thread PGDIR and
> >>avoid reading thread_struct.pgdir at every TLB miss.
> >>
> >This patch causes a number of silent (no crash) qemu boot stalls
> >in -next. See
> >https://kerneltests.org/builders/qemu-ppc-next/builds/1080/steps/qemubuildcommand/logs/stdio
> >for an example.
>
> Oops.
> Could you try the fix below ?
>

Yes, that does the trick. With this patch applied on top of next-20190306,
all my ppc qemu boot tests pass.

Tested-by: Guenter Roeck <linux@roeck-us.net>

Guenter

> diff --git a/arch/powerpc/kernel/cpu_setup_6xx.S
> b/arch/powerpc/kernel/cpu_setup_6xx.S
> index 6f1c11e0691f..7534ecff5e92 100644
> --- a/arch/powerpc/kernel/cpu_setup_6xx.S
> +++ b/arch/powerpc/kernel/cpu_setup_6xx.S
> @@ -24,9 +24,6 @@ BEGIN_MMU_FTR_SECTION
> li r10,0
> mtspr SPRN_SPRG_603_LRU,r10 /* init SW LRU tracking */
> END_MMU_FTR_SECTION_IFSET(MMU_FTR_NEED_DTLB_SW_LRU)
> - lis r10, (swapper_pg_dir - PAGE_OFFSET)@h
> - ori r10, r10, (swapper_pg_dir - PAGE_OFFSET)@l
> - mtspr SPRN_SPRG_PGDIR, r10
>
> BEGIN_FTR_SECTION
> bl __init_fpu_registers
> diff --git a/arch/powerpc/kernel/head_32.S b/arch/powerpc/kernel/head_32.S
> index ce6a972f2584..48051c8977c5 100644
> --- a/arch/powerpc/kernel/head_32.S
> +++ b/arch/powerpc/kernel/head_32.S
> @@ -855,6 +855,9 @@ __secondary_start:
> li r3,0
> stw r3, RTAS_SP(r4) /* 0 => not in RTAS */
> #endif
> + lis r4, (swapper_pg_dir - PAGE_OFFSET)@h
> + ori r4, r4, (swapper_pg_dir - PAGE_OFFSET)@l
> + mtspr SPRN_SPRG_PGDIR, r4
>
> /* enable MMU and jump to start_secondary */
> li r4,MSR_KERNEL
> @@ -942,6 +945,9 @@ start_here:
> li r3,0
> stw r3, RTAS_SP(r4) /* 0 => not in RTAS */
> #endif
> + lis r4, (swapper_pg_dir - PAGE_OFFSET)@h
> + ori r4, r4, (swapper_pg_dir - PAGE_OFFSET)@l
> + mtspr SPRN_SPRG_PGDIR, r4
>
> /* stack */
> lis r1,init_thread_union@ha
> diff --git a/arch/powerpc/mm/hash_low_32.S b/arch/powerpc/mm/hash_low_32.S
> index 1f13494efb2b..587e4550d83e 100644
> --- a/arch/powerpc/mm/hash_low_32.S
> +++ b/arch/powerpc/mm/hash_low_32.S
> @@ -70,12 +70,12 @@ _GLOBAL(hash_page)
> lis r0,KERNELBASE@h /* check if kernel address */
> cmplw 0,r4,r0
> ori r3,r3,_PAGE_USER|_PAGE_PRESENT /* test low addresses as user */
> - mfspr r5, SPRN_SPRG_PGDIR /* virt page-table root */
> + mfspr r5, SPRN_SPRG_PGDIR /* phys page-table root */
> blt+ 112f /* assume user more likely */
> - lis r5,swapper_pg_dir@ha /* if kernel address, use */
> - addi r5,r5,swapper_pg_dir@l /* kernel page table */
> + lis r5, (swapper_pg_dir - PAGE_OFFSET)@ha /* if kernel address, use */
> + addi r5 ,r5 , (swapper_pg_dir - PAGE_OFFSET)@l /* kernel page table */
> rlwimi r3,r9,32-12,29,29 /* MSR_PR -> _PAGE_USER */
> -112: tophys(r5, r5)
> +112:
> #ifndef CONFIG_PTE_64BIT
> rlwimi r5,r4,12,20,29 /* insert top 10 bits of address */
> lwz r8,0(r5) /* get pmd entry */
>
>
> Thanks
> Christophe
>
> >
> >Unfortunately, it is not possible to revert the patch due to subsequent
> >patches, so I was unable to test a revert.
> >
> >Bisect log is attached.
> >
> >Guenter
> >
> >---
> ># bad: [cf08baa29613dd899954089e7cc7dba1d478b365] Add linux-next specific files for 20190306
> ># good: [1c163f4c7b3f621efff9b28a47abb36f7378d783] Linux 5.0
> >git bisect start 'HEAD' 'v5.0'
> ># bad: [6cc8f3499ec8d31904ab9083980a91736512cb37] Merge remote-tracking branch 'vfs/for-next'
> >git bisect bad 6cc8f3499ec8d31904ab9083980a91736512cb37
> ># good: [63bdf4284c38a48af21745ceb148a087b190cd21] Merge branch 'linus' of git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6
> >git bisect good 63bdf4284c38a48af21745ceb148a087b190cd21
> ># good: [520b5fc601ab760fee7ea0c403b42d04e8ebfd93] Merge remote-tracking branch 'arm-soc/for-next'
> >git bisect good 520b5fc601ab760fee7ea0c403b42d04e8ebfd93
> ># bad: [d7f54e4e0d4e90f5df78da8d6a830bafad3b535a] Merge remote-tracking branch 'xtensa/xtensa-for-next'
> >git bisect bad d7f54e4e0d4e90f5df78da8d6a830bafad3b535a
> ># good: [0c1a78523542fb3d2e6c5ac7955c8ca8f6482e6f] Merge remote-tracking branch 'clk/clk-next'
> >git bisect good 0c1a78523542fb3d2e6c5ac7955c8ca8f6482e6f
> ># bad: [fb0b0a73b223fc113e961b1d921322844e9c30d9] powerpc: Enable kcov
> >git bisect bad fb0b0a73b223fc113e961b1d921322844e9c30d9
> ># good: [d0055df0c9c1471c389197a69f43e300185a75aa] Merge branch 'topic/dma' into next
> >git bisect good d0055df0c9c1471c389197a69f43e300185a75aa
> ># good: [0df977eafc792a5365a7f81d8d5920132e03afad] powerpc/6xx: Don't use SPRN_SPRG2 for storing stack pointer while in RTAS
> >git bisect good 0df977eafc792a5365a7f81d8d5920132e03afad
> ># bad: [665bed2386e5dc29844ad78c7ef1464664b103ec] powerpc/8xx: replace most #ifdef by IS_ENABLED() in 8xx_mmu.c
> >git bisect bad 665bed2386e5dc29844ad78c7ef1464664b103ec
> ># bad: [78ca1108b10927b3d068c8da91352b0f4cd01fc5] powerpc/book3s32: Reorder _PAGE_XXX flags to simplify TLB handling
> >git bisect bad 78ca1108b10927b3d068c8da91352b0f4cd01fc5
> ># bad: [a8a121995b2e4f227fddc534c6bd5f1c02cbe2ee] powerpc/603: Don't handle kernel page TLB misses when not need
> >git bisect bad a8a121995b2e4f227fddc534c6bd5f1c02cbe2ee
> ># bad: [2c12393f577396a51b7e0537bd3eb29dcc26dc1b] powerpc/603: use physical address directly in TLB miss handlers.
> >git bisect bad 2c12393f577396a51b7e0537bd3eb29dcc26dc1b
> ># bad: [93c4a162b014d238a287f8264adb25c009c79e61] powerpc/6xx: Store PGDIR physical address in a SPRG
> >git bisect bad 93c4a162b014d238a287f8264adb25c009c79e61
> ># first bad commit: [93c4a162b014d238a287f8264adb25c009c79e61] powerpc/6xx: Store PGDIR physical address in a SPRG
> >

\
 
 \ /
  Last update: 2019-03-07 20:08    [W:0.052 / U:0.120 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site