lkml.org 
[lkml]   [2019]   [Mar]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] irqchip: stm32: don't set rising configuration registers at init
From
Date
On 07/03/2019 16:15, Fabien Dessenne wrote:
> The rising configuration status register (rtsr) is not banked.
> As it is shared with the co-processor, it should not be written at probe
> time, else the co-processor configuration will be lost.
>
> Signed-off-by: Fabien Dessenne <fabien.dessenne@st.com>

Fixes:?

> ---
> drivers/irqchip/irq-stm32-exti.c | 5 -----
> 1 file changed, 5 deletions(-)
>
> diff --git a/drivers/irqchip/irq-stm32-exti.c b/drivers/irqchip/irq-stm32-exti.c
> index 6edfd4b..ff8a84f 100644
> --- a/drivers/irqchip/irq-stm32-exti.c
> +++ b/drivers/irqchip/irq-stm32-exti.c
> @@ -716,7 +716,6 @@ stm32_exti_chip_data *stm32_exti_chip_init(struct stm32_exti_host_data *h_data,
> const struct stm32_exti_bank *stm32_bank;
> struct stm32_exti_chip_data *chip_data;
> void __iomem *base = h_data->base;
> - u32 irqs_mask;
>
> stm32_bank = h_data->drv_data->exti_banks[bank_idx];
> chip_data = &h_data->chips_data[bank_idx];
> @@ -725,10 +724,6 @@ stm32_exti_chip_data *stm32_exti_chip_init(struct stm32_exti_host_data *h_data,
>
> raw_spin_lock_init(&chip_data->rlock);
>
> - /* Determine number of irqs supported */
> - writel_relaxed(~0UL, base + stm32_bank->rtsr_ofst);
> - irqs_mask = readl_relaxed(base + stm32_bank->rtsr_ofst);
> -

And I guess you don't need to find out the number of supported IRQs?

Also, a handful of lines down, you're writing again to the same
register. Why isn't that a problem?

> /*
> * This IP has no reset, so after hot reboot we should
> * clear registers to avoid residue
>

Thanks,

M.
--
Jazz is not dead. It just smells funny...

\
 
 \ /
  Last update: 2019-03-07 17:40    [W:0.049 / U:24.608 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site