lkml.org 
[lkml]   [2019]   [Mar]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v8 1/2] spi: Add Renesas R-Car Gen3 RPC-IF SPI controller driver
From
Date
Hello!

On 03/27/2019 04:32 AM, masonccyang@mxic.com.tw wrote:

>> >>>> +static void rpc_spi_mem_set_prep_op_cfg(struct spi_device *spi,
>> >>>> + const struct spi_mem_op *op,
>> >>>> + u64 *offs, size_t *len)
>> >>>> +{
>> >>>> + struct rpc_spi *rpc = spi_controller_get_devdata(spi->controller);
>> >>>
>> >>>> + if (op->dummy.nbytes) {
>> >>>> + rpc->smenr |= RPC_SMENR_DME;
>> >>>> + rpc->dummy = RPC_SMDMCR_DMCYC(op->dummy.nbytes);
>> >>>
>> >>> SMDMCR.DMCYC is in bits -- you forgot to multiply by 8.
>> >>
>> >> ?
>> >>
>> >> It's dummy cycles setting, i.e,. 0 is 1 cycle dummy and
>> >
>> > Yeah, I should've written "cycles", sorry about that.
>>
>> I also should've mentioned that w/o this change the "read SFDP" command
>> returns garbage and the flash doesn't work.
>>
>
> Have you checked the dummy cycles setting with logical analysis ?

I don't have a logic analyzer (if you meant it). However, I dumped all the registers
in your driver and Cogent's own driver, and SMDMCR was set to 0 in your driver and to
7 in our driver -- and only our driver then worked correctly.

> As datasheet mentioned it's dummy cycles depends on the transfer bit size setting = 1, 4 or 8.
> Setting RPC_SMDMCR_DMCYC(0x13) in 8 bits data width I got a 20 dummy cycles.
> Also confirmed these 20 dummy cycles by logical analysis equipment.

[...]

> best regards,
> Mason

MBR, Sergei

\
 
 \ /
  Last update: 2019-03-27 11:22    [W:0.180 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site