Messages in this thread | | | Date | Sat, 23 Mar 2019 10:15:05 +0100 | From | Borislav Petkov <> | Subject | Re: [PATCH] EDAC, altera: Fix S10 Double Bit Error Notification |
| |
On Wed, Mar 13, 2019 at 10:27:22AM -0500, thor.thayer@linux.intel.com wrote: > From: Thor Thayer <thor.thayer@linux.intel.com> > > Stratix10 Double Bit Error Address was always read from > SDRAM Address register instead of each device's Address > register. > To determine which device had the DBE, cycle through > the EDAC devices comparing the DBE value to the db_irq > value. Once found, report the DBE Address from the device > registers as well as the device name. > Finally, notify the system via an SMC call and indicate > the panic should result in a system reboot. > Change a run-time check to a Stratix10 compile-time check > for a clean SMC notification. > > Fixes: d5fc9125566c ("EDAC, altera: Combine Stratix10 and Arria10 probe functions") > Signed-off-by: Thor Thayer <thor.thayer@linux.intel.com> > --- > drivers/edac/altera_edac.c | 69 ++++++++++++++++++++++++++++++++++------------ > drivers/edac/altera_edac.h | 20 ++++++++++++++ > 2 files changed, 72 insertions(+), 17 deletions(-)
Applied, thanks.
-- Regards/Gruss, Boris.
Good mailing practices for 400: avoid top-posting and trim the reply.
| |