lkml.org 
[lkml]   [2019]   [Mar]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: r8169 only works in promisc mode
Date
I have done some more investigation, some of which I posted on the
Bugzilla bug.

I believe the promisc issue is due to the MAC address receive filter
being silently reset to the invalid burned-in address. I used wireshark
and determined that the outgoing MAC address after suspend is the
overridden value. Re-setting the overridden value with "ip link set eth0
address" appears to have no effect. Setting it to a different overridden
value works normally and resolves the packet loss issue. Removing the
module and re-inserting it also resolves the issue.

I also attempted to determine why the MAC address on boot is
8e:00:00:00:8e:8e. As far as I can tell, this value is burned into the
flash somewhere. I tried turning off the machine, unplugging the power,
pressing the power button several times, then plugging it back in and
immediately booting into Windows; the incorrect MAC address was shown.

This reminded me that I am experiencing another firmware-related issue,
namely that it appears that the machine is only able to reach S1 or
possibly S2 sleep mode, even when specifying S3, and even in Windows. I
think there may be some flash bitrot, but clearing the firmware
settings, by all of: in the interface, removing the battery, and setting
the jumper; had no effect. I also tried reinstalling the BIOS using the
vendor-provided Windows updater, which also had no effect.

In conclusion: I think my firmware is broken (even moreso than regular
PC firmware), but I believe there is in fact some bug with r8169 on
"RTL8211B" in 5.0-rc1.

I can try bisecting if someone more competent than me believes that
would be helpful.

Thanks,
Alex.

\
 
 \ /
  Last update: 2019-03-23 02:27    [W:0.029 / U:0.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site