lkml.org 
[lkml]   [2019]   [Mar]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v2] clk: at91: fix programmable clock for sama5d2
Date
Stephen,

Thanks for the review

On 18/03/2019 at 20:54, Stephen Boyd wrote:
> Quoting Nicolas Ferre (2019-03-18 03:50:45)
>> From: Matthias Wieloch <matthias.wieloch@few-bauer.de>
>>
>> The prescaler formula of the programmable clock has changed for sama5d2. Update
>> the driver accordingly.
>>
>> Fixes: a2038077de9a ("clk: at91: add sama5d2 PMC driver")
>> Cc: <stable@vger.kernel.org> # v4.20+
>> Signed-off-by: Nicolas Ferre <nicolas.ferre@microchip.com>
>> [nicolas.ferre@microchip.com: adapt the prescaler range,
>> fix clk_programmable_recalc_rate, split patch]
>> Signed-off-by: Matthias Wieloch <matthias.wieloch@few-bauer.de>
>> Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
>> ---
>> v2: adapt to v5.1-rc1
>> remove unneeded sentence about DT in commit message
>>
>> Stephen,
>>
>> I think it would be good to see this fix going upstream during v5.1-rc phase.
>
> Ok. I can apply this clk-fixes. I presume that things are real bad and
> it can't wait until v5.2?

To be perfectly clear, it's not a regression.
But as we're at the very beginning of the '-rc' phase and as it's a bug,
I was thinking about adding it now. But you to choose, no problem either
way.

>> @@ -60,10 +68,18 @@ static int clk_programmable_determine_rate(struct clk_hw *hw,
>> continue;
>>
>> parent_rate = clk_hw_get_rate(parent);
>> - for (shift = 0; shift < PROG_PRES_MASK; shift++) {
>> - tmp_rate = parent_rate >> shift;
>> - if (tmp_rate <= req->rate)
>> - break;
>> + if (layout->is_pres_direct) {
>> + for (shift = 0; shift <= layout->pres_mask; shift++) {
>> + tmp_rate = parent_rate / (shift + 1);
>> + if (tmp_rate <= req->rate)
>> + break;
>> + }
>> + } else {
>> + for (shift = 0; shift < layout->pres_mask; shift++) {
>> + tmp_rate = parent_rate >> shift;
>> + if (tmp_rate <= req->rate)
>> + break;
>> + }
>
> This looks like a lot of copy paste when the if statement could have been
> pulled into the for loop instead of duplicating the loops and
> surrounding if condition check for tmp_rate.

Stop condition of loops not being the same made me separate them instead
of adding artificial test conditions for shift == layout->pres_mask. I'm
not sure the other way around is more obvious then...

>
>> }
>>
>> if (tmp_rate > req->rate)


--
Nicolas Ferre
\
 
 \ /
  Last update: 2019-03-19 09:29    [W:0.105 / U:0.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site