lkml.org 
[lkml]   [2019]   [Mar]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] usb: dwc3: Enable GBit Ethernet on Odroid XU4
From
Date
Hi Jochen,

On 2019-02-08 20:35, Jochen Sprickerhof wrote:
> Hi Marek,
>
> * Marek Szyprowski <m.szyprowski@samsung.com> [2019-02-08 13:36]:
>>>>> On 21/01/19 16:02, Jochen Sprickerhof wrote:
>>>> [..]
>>>>>> I'm not sure why this it only works with the driver compiled into
>>>>>> the
>>>>>> kernel nor why it needs a hard reset or why it was the line was
>>>>>> dropped
>>>>>> when the patch was accepted. Would be great to get some feedback
>>>>>> of the
>>>>>> authors.
>>>>> When XHCI driver is compiled into the kernel are the relevant PHY
>>>>> drivers
>>>>> compiled in as well?
>>>> Only CONFIG_USB_PHY=y (I took the config from the
>>>> linux-image-4.19.0-1-armmp_4.19.13-1_armhf.deb Debian package as a
>>>> basis where this is the default).
>>
>> I confirm that on Odroid XU4 USB 3.0 works only when all related drivers
>> (dwc3, xhci and exynos5 drd phy) are compiled into the kernel. If they
>> are compiled as modules, USB 3.0 calibration doesn't work. The mentioned
>> patch doesn't fix anything.
>
> I've just tried Linux v5.0-rc5 with the Debian config and
> USB_XHCI_PLATFORM=y and it works, thanks!
>
> Is there a way to make it work with xhci compiled as a module, so it
> would work in Debian out of the box?

One more comment - 5000M mode will also work with everything compiled as
modules (dwc3, exynos5 drd phy and xhci-plat) too. Just make sure that
xhci-plat is loaded before dwc3. This would require some manual
configuration, because autoloading will load xhci-plat after dwc3 probe
and switch to host mode.

Best regards
--
Marek Szyprowski, PhD
Samsung R&D Institute Poland

\
 
 \ /
  Last update: 2019-03-11 12:12    [W:0.081 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site