lkml.org 
[lkml]   [2019]   [Mar]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH net-next v2 09/15] net: mvpp2: always disable both MACs when disabling a port
Date
This patch modifies the port_disable() helper to always disable both the
GMAC and the XLG MAC when called. At boot time we do not know of a port
was enabled in the firmware/bootloader, and if so what mode was used
(hence which of the two MACs was used).

This also help in implementing a logic where all blocks are disabled
when not used, and only enabled regarding the current mode used on a
given port.

Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
---
drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index 11284918d907..b27966355df9 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -1214,11 +1214,11 @@ static void mvpp2_port_disable(struct mvpp2_port *port)
/* Disable & reset should be done separately */
val &= ~MVPP22_XLG_CTRL0_MAC_RESET_DIS;
writel(val, port->base + MVPP22_XLG_CTRL0_REG);
- } else {
- val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
- val &= ~(MVPP2_GMAC_PORT_EN_MASK);
- writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
}
+
+ val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
+ val &= ~(MVPP2_GMAC_PORT_EN_MASK);
+ writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
}

/* Set IEEE 802.3x Flow Control Xon Packet Transmission Mode */
--
2.20.1
\
 
 \ /
  Last update: 2019-03-01 11:56    [W:0.061 / U:0.776 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site