lkml.org 
[lkml]   [2019]   [Feb]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] parisc: use memblock_alloc() instead of custom get_memblock()
On Thu, Feb 21, 2019 at 11:00:05AM +0100, Helge Deller wrote:
> On 21.02.19 10:07, Mike Rapoport wrote:
> > On Tue, Feb 12, 2019 at 05:16:12PM +0200, Mike Rapoport wrote:
> >> The get_memblock() function implements custom bottom-up memblock allocator.
> >> Setting 'memblock_bottom_up = true' before any memblock allocation is done
> >> allows replacing get_memblock() calls with memblock_alloc().
>
> >> Signed-off-by: Mike Rapoport <rppt@linux.ibm.com>
>
> Acked-by: Helge Deller <deller@gmx.de>
> Tested-by: Helge Deller <deller@gmx.de>
>
> Thanks!
> Shall I push the patch upstream with the parisc tree?

Yes, please.

> Helge
>
>
>
> >> ---
> >> v2: fix allocation alignment
> >>
> >> arch/parisc/mm/init.c | 52 +++++++++++++++++++--------------------------------
> >> 1 file changed, 19 insertions(+), 33 deletions(-)
> >>
> >> diff --git a/arch/parisc/mm/init.c b/arch/parisc/mm/init.c
> >> index 059187a..d0b1662 100644
> >> --- a/arch/parisc/mm/init.c
> >> +++ b/arch/parisc/mm/init.c
> >> @@ -79,36 +79,6 @@ static struct resource sysram_resources[MAX_PHYSMEM_RANGES] __read_mostly;
> >> physmem_range_t pmem_ranges[MAX_PHYSMEM_RANGES] __read_mostly;
> >> int npmem_ranges __read_mostly;
> >>
> >> -/*
> >> - * get_memblock() allocates pages via memblock.
> >> - * We can't use memblock_find_in_range(0, KERNEL_INITIAL_SIZE) here since it
> >> - * doesn't allocate from bottom to top which is needed because we only created
> >> - * the initial mapping up to KERNEL_INITIAL_SIZE in the assembly bootup code.
> >> - */
> >> -static void * __init get_memblock(unsigned long size)
> >> -{
> >> - static phys_addr_t search_addr __initdata;
> >> - phys_addr_t phys;
> >> -
> >> - if (!search_addr)
> >> - search_addr = PAGE_ALIGN(__pa((unsigned long) &_end));
> >> - search_addr = ALIGN(search_addr, size);
> >> - while (!memblock_is_region_memory(search_addr, size) ||
> >> - memblock_is_region_reserved(search_addr, size)) {
> >> - search_addr += size;
> >> - }
> >> - phys = search_addr;
> >> -
> >> - if (phys)
> >> - memblock_reserve(phys, size);
> >> - else
> >> - panic("get_memblock() failed.\n");
> >> -
> >> - memset(__va(phys), 0, size);
> >> -
> >> - return __va(phys);
> >> -}
> >> -
> >> #ifdef CONFIG_64BIT
> >> #define MAX_MEM (~0UL)
> >> #else /* !CONFIG_64BIT */
> >> @@ -321,6 +291,13 @@ static void __init setup_bootmem(void)
> >> max_pfn = start_pfn + npages;
> >> }
> >>
> >> + /*
> >> + * We can't use memblock top-down allocations because we only
> >> + * created the initial mapping up to KERNEL_INITIAL_SIZE in
> >> + * the assembly bootup code.
> >> + */
> >> + memblock_set_bottom_up(true);
> >> +
> >> /* IOMMU is always used to access "high mem" on those boxes
> >> * that can support enough mem that a PCI device couldn't
> >> * directly DMA to any physical addresses.
> >> @@ -442,7 +419,10 @@ static void __init map_pages(unsigned long start_vaddr,
> >> */
> >>
> >> if (!pmd) {
> >> - pmd = (pmd_t *) get_memblock(PAGE_SIZE << PMD_ORDER);
> >> + pmd = memblock_alloc(PAGE_SIZE << PMD_ORDER,
> >> + PAGE_SIZE << PMD_ORDER);
> >> + if (!pmd)
> >> + panic("pmd allocation failed.\n");
> >> pmd = (pmd_t *) __pa(pmd);
> >> }
> >>
> >> @@ -461,7 +441,10 @@ static void __init map_pages(unsigned long start_vaddr,
> >>
> >> pg_table = (pte_t *)pmd_address(*pmd);
> >> if (!pg_table) {
> >> - pg_table = (pte_t *) get_memblock(PAGE_SIZE);
> >> + pg_table = memblock_alloc(PAGE_SIZE,
> >> + PAGE_SIZE);
> >> + if (!pg_table)
> >> + panic("page table allocation failed\n");
> >> pg_table = (pte_t *) __pa(pg_table);
> >> }
> >>
> >> @@ -700,7 +683,10 @@ static void __init pagetable_init(void)
> >> }
> >> #endif
> >>
> >> - empty_zero_page = get_memblock(PAGE_SIZE);
> >> + empty_zero_page = memblock_alloc(PAGE_SIZE, PAGE_SIZE);
> >> + if (!empty_zero_page)
> >> + panic("zero page allocation failed.\n");
> >> +
> >> }
> >>
> >> static void __init gateway_init(void)
> >> --
> >> 2.7.4
> >>
> >
>

--
Sincerely yours,
Mike.

\
 
 \ /
  Last update: 2019-02-21 12:16    [W:0.045 / U:1.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site