lkml.org 
[lkml]   [2019]   [Feb]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] gpio: of: Restrict enable-gpio quirk to regulator-gpio
Date
On 2/20/19 11:52 AM, Thierry Reding wrote:
> From: Thierry Reding <treding@nvidia.com>
>
> Commit 0e7d6f940164 ("gpio: of: Apply regulator-gpio quirk only to
> enable-gpios") breaks the device tree ABI specified in the device tree
> bindings for fixed regulators (compatible "regulator-fixed"). According
> to these bindings the polarity of the GPIO is exclusively controlled by
> the presence or absence of the enable-active-high property. As such the
> polarity quirk implemented in of_gpio_flags_quirks() must be applied to
> the GPIO specified for fixed regulators.
>
> However, commit 0e7d6f940164 ("gpio: of: Apply regulator-gpio quirk only
> to enable-gpios") restricted the quirk to the enable-gpios property for
> fixed regulators as well, whereas according to the commit message itself
> it should only apply to "regulator-gpio" compatible device tree nodes.
>
> Fix this by actually implementing what the offending commit intended,
> which is to ensure that the quirk is applied to the GPIO specified by
> the "enable-gpio" property for the "regulator-gpio" bindings only.
>
> This fixes a regression on Jetson TX1 where the fixed regulator for the
> HDMI +5V pin relies on the flags quirk for the proper polarity.
>
> Fixes: 0e7d6f940164 ("gpio: of: Apply regulator-gpio quirk only to enable-gpios")
> Signed-off-by: Thierry Reding <treding@nvidia.com>
> ---
> drivers/gpio/gpiolib-of.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpio/gpiolib-of.c b/drivers/gpio/gpiolib-of.c
> index 1b4c741e0635..bddfc6102a50 100644
> --- a/drivers/gpio/gpiolib-of.c
> +++ b/drivers/gpio/gpiolib-of.c
> @@ -84,10 +84,10 @@ static void of_gpio_flags_quirks(struct device_node *np,
> * Note that active low is the default.
> */
> if (IS_ENABLED(CONFIG_REGULATOR) &&
> - !strcmp(propname, "enable-gpio") &&
> (of_device_is_compatible(np, "regulator-fixed") ||
> of_device_is_compatible(np, "reg-fixed-voltage") ||
> - of_device_is_compatible(np, "regulator-gpio"))) {
> + (of_device_is_compatible(np, "regulator-gpio") &&
> + strcmp(propname, "enable-gpio") == 0))) {
> /*
> * The regulator GPIO handles are specified such that the
> * presence or absence of "enable-active-high" solely controls

On R8A7795 Salvator-XS
Tested-by: Marek Vasut <marek.vasut@gmail.com>

--
Best regards,
Marek Vasut

\
 
 \ /
  Last update: 2019-02-20 12:16    [W:0.056 / U:0.536 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site