lkml.org 
[lkml]   [2019]   [Feb]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 13/15] ARM: dts: milbeaut: Add device tree set for the Milbeaut M10V board
From
Date
Hi,

On 2019/02/19 19:11, Arnd Bergmann wrote:
> On Tue, Feb 19, 2019 at 6:11 AM Sugaya, Taichi
> <sugaya.taichi@socionext.com> wrote:
>>
>> Hi,
>> Thank you for you comments.
>>
>> On 2019/02/18 21:09, Arnd Bergmann wrote:
>>> On Fri, Feb 8, 2019 at 1:28 PM Sugaya Taichi
>>> <sugaya.taichi@socionext.com> wrote:
>>>> +
>>>> + aliases {
>>>> + serial1 = &uart1;
>>>> + };
>>>
>>> Maybe start with serial0 here? It seems unusual to start
>>> counting at 1.
>>>
>>
>> The M10V evaluation board(EVB) uses a console with uart ch1, so this
>> alias number is derived from the used channel one.
>> Therefore it is no problem to change the alias number to 0.
>
> The alias should normally reflect whatever is printed on the board,
> if there are no labels, the convention is to start with zero, regardless
> of what internal uart is connected to it.
>

I got it.
I use a "serial0" beacause there are no labels about uart ch on M10V EVB.

Thanks,
Sugaya Taichi

> Arnd
>

\
 
 \ /
  Last update: 2019-02-20 06:30    [W:0.048 / U:0.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site