lkml.org 
[lkml]   [2019]   [Feb]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/9] dt-bindings: mtd: ingenic: Add compatible strings for the JZ4740
Date
Add compatible strings to probe the jz4780-nand and jz4780-bch drivers
from devicetree on the JZ4725B and JZ4740 SoCs from Ingenic.

Signed-off-by: Paul Cercueil <paul@crapouillou.net>
---

Changes:

v2: - Change 'ingenic,jz4725b-nand' compatible string to
'ingenic,jz4740-nand' to reflect driver change
- Add 'ingenic,jz4740-bch' compatible string
- Document 'ingenic,oob-layout' property

.../devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
index 29ea5853ca91..294b56a2098a 100644
--- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
@@ -6,7 +6,9 @@ memory-controllers/ingenic,jz4780-nemc.txt), and thus NAND device nodes must
be children of the NEMC node.

Required NAND controller device properties:
-- compatible: Should be set to "ingenic,jz4780-nand".
+- compatible: Should be one of:
+ * ingenic,jz4740-nand
+ * ingenic,jz4780-nand
- reg: For each bank with a NAND chip attached, should specify a bank number,
an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank).

@@ -15,6 +17,10 @@ Optional NAND controller device properties:
property must contain a phandle for the BCH controller node. The required
properties for this node are described below. If this is not specified,
software BCH will be used instead.
+- ingenic,oob-layout: Specify the OOB layout to replace the default one.
+ Valid values are:
+ * ingenic,jz4725b
+ * qi,lb60

Optional children nodes:
- Individual NAND chips are children of the NAND controller node.
@@ -72,7 +78,10 @@ NAND devices. The following is a description of the device properties for a
BCH controller.

Required BCH properties:
-- compatible: Should be set to "ingenic,jz4780-bch".
+- compatible: Should be one of:
+ * ingenic,jz4740-bch
+ * ingenic,jz4725b-bch
+ * ingenic,jz4780-bch
- reg: Should specify the BCH controller registers location and length.
- clocks: Clock for the BCH controller.

--
2.20.1
\
 
 \ /
  Last update: 2019-02-03 00:20    [W:0.168 / U:4.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site