lkml.org 
[lkml]   [2019]   [Feb]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4/8] dt-bindings: regulator: remove regulator pull-down support for stpmic1
Date
Regulator high pull down are enabled by default so remove support in the
driver.

Signed-off-by: Pascal Paillet <p.paillet@st.com>
---
Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt | 2 --
1 file changed, 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt b/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
index de27897..bf9385b 100644
--- a/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
@@ -23,8 +23,6 @@ Switches are fixed voltage regulators with only enable/disable capability.
Optional properties:
- st,mask-reset: mask reset for this regulator: the regulator configuration
is maintained during pmic reset.
-- regulator-pull-down: enable high pull down
- if not specified light pull down is used
- regulator-over-current-protection:
if set, all regulators are switched off in case of over-current detection
on this regulator,
--
1.9.1
\
 
 \ /
  Last update: 2019-02-19 11:05    [W:0.088 / U:0.284 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site