lkml.org 
[lkml]   [2019]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH 6/8] dt-bindings: net: stmmac: add syscfg clock property
    Date
    Need syscfg clock for MCU family in case bootloader does not
    activate it.

    Signed-off-by: Christophe Roullier <christophe.roullier@st.com>
    ---
    Documentation/devicetree/bindings/net/stm32-dwmac.txt | 4 ++--
    1 file changed, 2 insertions(+), 2 deletions(-)

    diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.txt b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
    index f42dc68..524f8a0 100644
    --- a/Documentation/devicetree/bindings/net/stm32-dwmac.txt
    +++ b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
    @@ -14,8 +14,8 @@ Required properties:
    - clock-names: Should be "stmmaceth" for the host clock.
    Should be "mac-clk-tx" for the MAC TX clock.
    Should be "mac-clk-rx" for the MAC RX clock.
    - For MPU family need to add also "ethstp" for power mode clock and,
    - "syscfg-clk" for SYSCFG clock.
    + Should be "syscfg-clk" for the SYSCFG clock.
    + For MPU family need to add also "ethstp" for power mode clock
    - interrupt-names: Should contain a list of interrupt names corresponding to
    the interrupts in the interrupts property, if available.
    Should be "macirq" for the main MAC IRQ
    --
    2.7.4
    \
     
     \ /
      Last update: 2019-02-14 07:47    [W:3.151 / U:1.800 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site