lkml.org 
[lkml]   [2019]   [Dec]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 7/8] thermal: mediatek: add another get_temp ops for thermal sensors
From
Date
On Thu, 2019-11-21 at 15:00 +0800, Hsin-Yi Wang wrote:
> On Fri, May 10, 2019 at 9:27 PM michael.kao <michael.kao@mediatek.com> wrote:
>
> > - tzdev = devm_thermal_zone_of_sensor_register(&pdev->dev, 0, mt,
> > - &mtk_thermal_ops);
> > - if (IS_ERR(tzdev)) {
> > - ret = PTR_ERR(tzdev);
> > - goto err_disable_clk_peri_therm;
> > + for (i = 0; i < mt->conf->num_sensors + 1; i++) {
> > + tz = kmalloc(sizeof(*tz), GFP_KERNEL);
> > + if (!tz)
> > + return -ENOMEM;
> > +
> > + tz->mt = mt;
> > + tz->id = i;
> > +
> > + tzdev = devm_thermal_zone_of_sensor_register(&pdev->dev, i,
> > + tz, (i == 0) ?
> > + &mtk_thermal_ops : &mtk_thermal_sensor_ops);
> > +
> > + if (IS_ERR(tzdev)) {
> > + if (IS_ERR(tzdev) != -EACCES) {
> PTR_ERR(tzdev)
>
> > + ret = PTR_ERR(tzdev);
> > + goto err_disable_clk_peri_therm;
> > + }
> > + }
>
> This for loop adding thermal zone sensors will not work for mt8173. It
> assumes that thermal-zones in dts have subnodes (eg. cpu_thermal,
> tzts..) amount equal to num_sensors+1. Otherwise tzdev would be
> -ENODEV and thermal failed to be probed.
> In mt8183 this is fine, since each thermal zone only has one sensor,
> but in mt8173, some sensor appears in multiple thermal zones.
>
> In order to let the change also works for 8173, I think if the error
> is -ENODEV, and the id is not 0 (0 is cpu_thermal), prompt a warning
> instead of failing. Eg.
>
> if (IS_ERR(tzdev)) {
> + if (i > 0 && PTR_ERR(tzdev) == -ENODEV) {
> + dev_warn(&pdev->dev, "can't find
> thermal sensor %d\n", i);
> + continue;
> + }
> if (PTR_ERR(tzdev) != -EACCES) {

OK, I will update this patch.
\
 
 \ /
  Last update: 2019-12-06 10:36    [W:0.038 / U:2.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site