lkml.org 
[lkml]   [2019]   [Dec]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4] bluetooth: hci_bcm: enable IRQ capability from node
On Fri, Dec 13, 2019 at 11:55:21AM +0100, Guillaume La Roque wrote:
> Actually IRQ can be found from GPIO but all platforms don't support
> gpiod_to_irq, it's the case on amlogic chip.
> so to have possibility to use interrupt mode we need to add interrupts
> field in node and support it in driver.

"node" is a bit vague, please refer to devicetree here and in the patch
summary.

> Signed-off-by: Guillaume La Roque <glaroque@baylibre.com>
> ---
> drivers/bluetooth/hci_bcm.c | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c
> index f8f5c593a05c..aa194f8d703e 100644
> --- a/drivers/bluetooth/hci_bcm.c
> +++ b/drivers/bluetooth/hci_bcm.c
> @@ -13,6 +13,7 @@
> #include <linux/module.h>
> #include <linux/acpi.h>
> #include <linux/of.h>
> +#include <linux/of_irq.h>
> #include <linux/property.h>
> #include <linux/platform_data/x86/apple.h>
> #include <linux/platform_device.h>
> @@ -1421,6 +1422,7 @@ static int bcm_serdev_probe(struct serdev_device *serdev)
> #endif
> bcmdev->serdev_hu.serdev = serdev;
> serdev_device_set_drvdata(serdev, bcmdev);
> + bcmdev->irq = of_irq_get(bcmdev->dev->of_node, 0);

And this clearly makes no sense for acpi, so you'd need to add it to
bcm_of_probe().

Shouldn't you be used using of_irq_get_byname()?

And since you're extending the binding, I think you need a preparatory
patch documenting this in:

Documentation/devicetree/bindings/net/broadcom-bluetooth.txt

> /* Initialize routing field to an unused value */
> bcmdev->pcm_int_params[0] = 0xff;

Johan

\
 
 \ /
  Last update: 2019-12-13 12:17    [W:0.065 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site