lkml.org 
[lkml]   [2019]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation
On Wed, Dec 11, 2019 at 6:09 PM Marco Felsch <m.felsch@pengutronix.de> wrote:

> I discussed it with a colleague again and he mentioned that pinctrl
> should be named pinctrl instead it should be named padctrl.

Quoting Documentation/driver-api/pinctl.rst:

(...)
Definition of PIN:

- PINS are equal to pads, fingers, balls or whatever packaging input or
output line you want to control and these are denoted by unsigned integers
in the range 0..maxpin.
(...)

> We don't
> reconfigure the pad to a other function it is still a device general
> purpose input pad. The hw-signal flow goes always trough the gpio block
> so one argument more for my solution. Also we don't configure the "pad"
> to be a vsel/ena-pin. The hw-pad can only be a gpio or has an alternate
> function (WDKICK for GPIO0, Seq. SYS_EN for GPIO2, Seq. PWR_EN for GPIO4).
> Instead we tell the regulator to use _this_ GPIO e.g. for voltage
> selection so we go the other way around. My last argument why pinctrl
> isn't the correct place is that the GPIO1 can be used for
> regulator-0:vsel-in and for regulator-1:enable-in. So this pad would
> have different states which is invalid IMHO.

Yeah it is just one of these cases where the silicon designer pulled
a line of polysilicone over to the regulator enable signal and put a
switch on it and say "so you can also enable the regulator
with a signal from here", it can be used in parallel with anything
else, which is especially messy.

Special cases require special handling, since the electronic design
of this thing is a bit Rube Goldberg.

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2019-12-12 16:10    [W:0.173 / U:0.656 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site