Messages in this thread | | | Date | Wed, 11 Dec 2019 17:20:53 +0800 | From | Shawn Guo <> | Subject | Re: [PATCH] arm64: dts: ls1028a: put SAIs into async mode |
| |
On Fri, Nov 29, 2019 at 10:09:37PM +0100, Michael Walle wrote: > The LS1028A SoC has only unidirectional SAIs. Therefore, it doesn't make > sense to have the RX and TX part synchronous. Even worse, the RX part > wont work out of the box because by default it is configured as > synchronous to the TX part. And as said before, the pinmux of the SoC > can only be configured to route either the RX or the TX signals to the > SAI but never both at the same time. Thus configure the asynchronous > mode by default. > > Signed-off-by: Michael Walle <michael@walle.cc>
Applied, thanks.
| |