lkml.org 
[lkml]   [2019]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] mm/hotplug: Only respect mem= parameter during boot stage
On 12/10/19 at 12:33pm, Michal Hocko wrote:
> On Tue 10-12-19 18:43:03, Baoquan He wrote:
> > On 12/10/19 at 11:28am, Michal Hocko wrote:
> > > On Tue 10-12-19 15:24:53, Baoquan He wrote:
> [...]
> > > > But after system bootup, we should be able to hot add/remove any memory
> > > > board. This should not be restricted by a boot-time kernel parameter
> > > > 'mme='. This is what I am trying to fix.
> > >
> > > This is a simple statement without any actual explanation on why. Why is
> > > hotplug memory special? What is the usecase? Who would want to use mem
> > > parameter and later expect a memory above the restrected area to be
> > > hotplugable?
> >
> > The why is 'mem=' is used to restrict the amount of system ram during
> > boot. We have two ways to add system memory, one is installing DIMMs
> > before boot, the other is hot adding memory after boot. Without David's
> > use case, we may need redefine 'mem=' and change its documentation in
> > kernel-parameters.txt, if we don't want to fix it like this. Otherwise,
> > 'mem=' will limit the system's upper system ram always, that is not
> > expected.
>
> I really do not see why. It seems a pretty consistent behavior to me.
> Because it essentially cut any memory above the given size. If a new
> hotplugable memory fits into that cap then it just shows up. Quite
> contrary I would consider it unexpected that a memory higher than the
> given mem=XYZ is really there. But I do recognize a real usecase
> mentioned elsewhere which beats the consistency argument here because
> all setups where such a restriction would be really important are
> debugging/workaround AFAICS.

All right. There could be me who have this misunderstanding.

Anyway, I think now we all agree it's only a boot-time restriction on
the system RAM.

Btw, as you said at above, I am confused by the '[KNL,BOOT]', what does
the 'BOOT' mean in the documentation of 'mem='? I checked all parameters
with 'BOOT', still don't get it clearly.

Thanks
Baoquan

\
 
 \ /
  Last update: 2019-12-10 13:57    [W:0.045 / U:0.400 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site