lkml.org 
[lkml]   [2019]   [Nov]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v7 18/19] PM / devfreq: tegra30: Tune up MCCPU boost-down coefficient
From
Date
On 19. 10. 30. 오전 7:00, Dmitry Osipenko wrote:
> MCCPU boosts up very aggressively by 800% and boosts down very mildly by
> 10%. This doesn't work well when system is idling because the very slow
> de-boosting results in lots of consecutive-down interrupts, in result
> memory stays clocked high and CPU doesn't enter deepest idling state
> instead of keeping memory at lowest freq and having CPU cluster turned
> off. A more faster de-boosting fixes the case of idling system and doesn't
> affect the case of an active system.
>
> Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
> ---
> drivers/devfreq/tegra30-devfreq.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/devfreq/tegra30-devfreq.c b/drivers/devfreq/tegra30-devfreq.c
> index d0dd42856e5b..9a21a29198ee 100644
> --- a/drivers/devfreq/tegra30-devfreq.c
> +++ b/drivers/devfreq/tegra30-devfreq.c
> @@ -123,7 +123,7 @@ static const struct tegra_devfreq_device_config actmon_device_configs[] = {
> .offset = 0x200,
> .irq_mask = 1 << 25,
> .boost_up_coeff = 800,
> - .boost_down_coeff = 90,
> + .boost_down_coeff = 40,
> .boost_up_threshold = 27,
> .boost_down_threshold = 10,
> .avg_dependency_threshold = 50000,
>

Reviewed-by: Chanwoo Choi <cw00.choi@samsung.com>

IMO, I think that it is not good to change the threshold value
on device driver directly when some requirement happen.
Instead, better to get the threshold value from device-tree file.


--
Best Regards,
Chanwoo Choi
Samsung Electronics


\
 
 \ /
  Last update: 2019-11-01 08:41    [W:0.292 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site