Messages in this thread | | | From | Tomasz Figa <> | Date | Thu, 17 Oct 2019 19:40:08 +0900 | Subject | Re: [PATCH] media: ov5695: enable vsync pin output |
| |
Hi Xingyu,
On Fri, Oct 11, 2019 at 7:39 PM <wuxy@bitland.com.cn> wrote: > > From: wuxy <wuxy@bitland.corp-partner.google.com> >
Thanks for the patch! Please see my comments inline.
> For Kukui project, the ov5695 vsync signal needs to > be set to output,from ov5695 datasheet,the related > register control methods as follows: > > 0x3002 Bit[7] FISIN/VSYNC output enable > 0x3010 Bit[7] enable FISIN/VSYNC as GPIO controlled by register > 0x3008 Bit[7] register control FISIN/VSYNC output > > TEST= boot to shell > > Signed-off-by: Xingyu Wu <wuxy@bitland.corp-partner.google.com> > --- > drivers/media/i2c/ov5695.c | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/drivers/media/i2c/ov5695.c b/drivers/media/i2c/ov5695.c > index 34b7046d9702..71f0eae6037b 100644 > --- a/drivers/media/i2c/ov5695.c > +++ b/drivers/media/i2c/ov5695.c > @@ -300,6 +300,9 @@ static const struct regval ov5695_global_regs[] = { > * mipi_datarate per lane 840Mbps > */ > static const struct regval ov5695_2592x1944_regs[] = { > + {0x3002, 0x80},
The original value of 0xa1 that was in ov5695_global_regs[], has the 0x80 bit set already.
> + {0x3008, 0x80}, > + {0x3010, 0x80},
Doesn't this configure the pin to an always-1 output GPIO? I believe the correct settings for both bits should be 0 and 0 for the pin to be driven by the hardware vsync generator.
Best regards, Tomasz
| |