[lkml]   [2019]   [Jan]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH 4/5] ARM: dts: sun5i: q8-tablet: Add LCD Panel power supply
The A13 Q8 tablet, following the A13 reference tablet design, has the
system's fixed 3.3V rail feed the VCC supply of the LCD panel.
Additional voltage rails used by the panel are generated using a
regulator fed from the unregulated IPSOUT output of the PMIC. The latter
is unrepresentable in the device tree. Both are controlled with MOSFETs
by the enable GPIO added in the previous patch. The actual enable or
reset pin for the panel is tied directly to LCD-VCC after the MOSFET.

Signed-off-by: Chen-Yu Tsai <>
arch/arm/boot/dts/sun5i-a13-q8-tablet.dts | 1 +
1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/sun5i-a13-q8-tablet.dts b/arch/arm/boot/dts/sun5i-a13-q8-tablet.dts
index ead159f89e74..c77c0758145a 100644
--- a/arch/arm/boot/dts/sun5i-a13-q8-tablet.dts
+++ b/arch/arm/boot/dts/sun5i-a13-q8-tablet.dts
@@ -50,6 +50,7 @@

panel: panel {
compatible = "urt,umsh-8596md-t", "simple-panel";
+ power-supply = <&reg_vcc3v3>;
enable-gpios = <&axp_gpio 0 GPIO_ACTIVE_HIGH>; /* AXP GPIO0 */
backlight = <&backlight>;
#address-cells = <1>;
 \ /
  Last update: 2019-01-27 15:49    [W:0.049 / U:0.780 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site