Messages in this thread | | | Date | Tue, 15 Jan 2019 17:54:42 +0100 | From | Miquel Raynal <> | Subject | Re: [PATCH v4 0/3] mtd: rawnand: add STM32 FMC2 NAND flash controller driver |
| |
Hi Christophe,
Christophe Kerello <christophe.kerello@st.com> wrote on Fri, 14 Dec 2018 10:58:05 +0100:
> This patchset adds the support for the STMicroelectronics FMC2 NAND flash > controller found on STM32MP SOCs. > > This patchset supports: > - the command sequencer feature, a hardware accelerator for read/write > within a page > - the manual mode feature, useful for debug purpose > - a maximum 8k page size > - following ECC strength and step size > - nand-ecc-strength = <8>, nand-ecc-step-size = <512> (BCH8) > - nand-ecc-strength = <4>, nand-ecc-step-size = <512> (BCH4) > - nand-ecc-strength = <1>, nand-ecc-step-size = <512> (Extended > ecc based on HAMMING) > > This patchset has been tested on Micron MT29F8G08ABACAH4 (8-bit SLC NAND) > and MT29F8G16ABACAH4 (16-bit SLC NAND)
Series applied on nand/next.
Thanks, Miquèl
| |