lkml.org 
[lkml]   [2018]   [Sep]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH] mm: hugepage: mark splitted page dirty when needed
On Thu, Sep 06, 2018 at 05:08:42PM +0300, Kirill A. Shutemov wrote:
> On Thu, Sep 06, 2018 at 07:39:33PM +0800, Peter Xu wrote:
> > On Wed, Sep 05, 2018 at 03:55:22PM +0300, Kirill A. Shutemov wrote:
> > > On Wed, Sep 05, 2018 at 03:30:37PM +0800, Peter Xu wrote:
> > > > On Tue, Sep 04, 2018 at 10:00:28AM -0400, Zi Yan wrote:
> > > > > On 4 Sep 2018, at 4:01, Kirill A. Shutemov wrote:
> > > > >
> > > > > > On Tue, Sep 04, 2018 at 03:55:10PM +0800, Peter Xu wrote:
> > > > > >> When splitting a huge page, we should set all small pages as dirty if
> > > > > >> the original huge page has the dirty bit set before. Otherwise we'll
> > > > > >> lose the original dirty bit.
> > > > > >
> > > > > > We don't lose it. It got transfered to struct page flag:
> > > > > >
> > > > > > if (pmd_dirty(old_pmd))
> > > > > > SetPageDirty(page);
> > > > > >
> > > > >
> > > > > Plus, when split_huge_page_to_list() splits a THP, its subroutine __split_huge_page()
> > > > > propagates the dirty bit in the head page flag to all subpages in __split_huge_page_tail().
> > > >
> > > > Hi, Kirill, Zi,
> > > >
> > > > Thanks for your responses!
> > > >
> > > > Though in my test the huge page seems to be splitted not by
> > > > split_huge_page_to_list() but by explicit calls to
> > > > change_protection(). The stack looks like this (again, this is a
> > > > customized kernel, and I added an explicit dump_stack() there):
> > > >
> > > > kernel: dump_stack+0x5c/0x7b
> > > > kernel: __split_huge_pmd+0x192/0xdc0
> > > > kernel: ? update_load_avg+0x8b/0x550
> > > > kernel: ? update_load_avg+0x8b/0x550
> > > > kernel: ? account_entity_enqueue+0xc5/0xf0
> > > > kernel: ? enqueue_entity+0x112/0x650
> > > > kernel: change_protection+0x3a2/0xab0
> > > > kernel: mwriteprotect_range+0xdd/0x110
> > > > kernel: userfaultfd_ioctl+0x50b/0x1210
> > > > kernel: ? do_futex+0x2cf/0xb20
> > > > kernel: ? tty_write+0x1d2/0x2f0
> > > > kernel: ? do_vfs_ioctl+0x9f/0x610
> > > > kernel: do_vfs_ioctl+0x9f/0x610
> > > > kernel: ? __x64_sys_futex+0x88/0x180
> > > > kernel: ksys_ioctl+0x70/0x80
> > > > kernel: __x64_sys_ioctl+0x16/0x20
> > > > kernel: do_syscall_64+0x55/0x150
> > > > kernel: entry_SYSCALL_64_after_hwframe+0x44/0xa9
> > > >
> > > > At the very time the userspace is sending an UFFDIO_WRITEPROTECT ioctl
> > > > to kernel space, which is handled by mwriteprotect_range(). In case
> > > > you'd like to refer to the kernel, it's basically this one from
> > > > Andrea's (with very trivial changes):
> > > >
> > > > https://git.kernel.org/pub/scm/linux/kernel/git/andrea/aa.git userfault
> > > >
> > > > So... do we have two paths to split the huge pages separately?
> > >
> > > We have two entiries that can be split: page table enties and underlying
> > > compound page.
> > >
> > > split_huge_pmd() (and variants of it) split the PMD entry into a PTE page
> > > table. It doens't touch underlying compound page. The page still can be
> > > mapped in other place as huge.
> > >
> > > split_huge_page() (and ivariants of it) split compound page into a number
> > > of 4k (or whatever PAGE_SIZE is). The operation requires splitting all
> > > PMD, but not other way around.
> > >
> > > >
> > > > Another (possibly very naive) question is: could any of you hint me
> > > > how the page dirty bit is finally applied to the PTEs? These two
> > > > dirty flags confused me for a few days already (the SetPageDirty() one
> > > > which sets the page dirty flag, and the pte_mkdirty() which sets that
> > > > onto the real PTEs).
> > >
> > > Dirty bit from page table entries transferes to sturct page flug and used
> > > for decision making in reclaim path.
> >
> > Thanks for explaining. It's much clearer for me.
> >
> > Though for the issue I have encountered, I am still confused on why
> > that dirty bit can be ignored for the splitted PTEs. Indeed we have:
> >
> > if (pmd_dirty(old_pmd))
> > SetPageDirty(page);
> >
> > However to me this only transfers (as you explained above) the dirty
> > bit (AFAIU it's possibly set by the hardware when the page is written)
> > to the page struct of the compound page. It did not really apply to
> > every small page of the splitted huge page. As you also explained,
> > this __split_huge_pmd() only splits the PMD entry but it keeps the
> > compound huge page there, then IMHO it should also apply the dirty
> > bits from the huge page to all the small page entries, no?
>
> The bit on compound page represents all small subpages. PageDirty() on any
> subpage will return you true if the compound page is dirty.

Ah I didn't notice this before (since PageDirty is defined with
PF_HEAD), thanks for pointing out.

>
> > These dirty bits are really important to my scenario since AFAIU the
> > change_protection() call is using these dirty bits to decide whether
> > it should append the WRITE bit - it finally corresponds to the lines
> > in change_pte_range():
> >
> > /* Avoid taking write faults for known dirty pages */
> > if (dirty_accountable && pte_dirty(ptent) &&
> > (pte_soft_dirty(ptent) ||
> > !(vma->vm_flags & VM_SOFTDIRTY))) {
> > ptent = pte_mkwrite(ptent);
> > }
> >
> > So when mprotect() with that range (my case is UFFDIO_WRITEPROTECT,
> > which is similar) although we pass in the new protocol with VM_WRITE
> > here it'll still mask it since the dirty bit is not set, then the
> > userspace program (in my case, the QEMU thread that handles write
> > protect failures) can never fixup the write-protected page fault.
>
> I don't follow here.
>
> The code you quoting above is an apportunistic optimization and should not
> be mission-critical. The dirty and writable bits can go away as soon as
> you drop page table lock for the page.

Indeed it's an optimization, IIUC it tries to avoid an extra but
possibly useless write-protect page fault when the dirty bits are
already set after all. However that's a bit trickly here - in my use
case the write-protect page faults will be handled by one of the QEMU
thread that reads the userfaultfd handle, so the fault must be handled
there instead of inside kernel otherwise there'll be nested page
faults forever (and userfaultfd will detect that then send a SIGBUS
instead).

I'll try to explain with some more details on how I understand what
happened. This should also answer Zi's question so I'll avoid
replying twice there. Please feel free to correct me.

Firstly, below should be the correct steps to handle a userspace write
protect page fault using Andrea's userfault-wp tree (I only mentioned
the page fault steps and ignored most of the irrelevant setup
procedures):

1. QEMU write-protects page P using UFFDIO_WRITEPROTECT ioctl, then
the write bit removed from PTE, so QEMU can capture any further
writes to the page

... (time passes)...

2. [vCPU thread] Guest writes to the page P, trigger wp page fault

3. [vCPU thread] Since the page (and the whole vma) is tracked by
userfault-wp, it goes into handle_userfault() to notify userspace
about the page fault and waits...

4. [userfault thread] Gets the message about the page fault, do
anything it like with the page P (mostly copy it somewhere), and
fixup the page fault by another UFFDIO_WRITEPROTECT ioctl, this
time to reset the write bit. After that, it'll wake up the vCPU
thread

5. [vCPU thread] Got waked up, retry the page fault by returning a
VM_FAULT_RETRY in handle_userfault(). Then this time we'll see the
PTE with write bit set correctly. vCPU continues execution.

Then let's consider THP here, where we might miss the dirty page for
the PTE of the small page P. In that case at step (4) when we want to
recover the write bit we'll fail since the dirty bit is missing in the
small PTE, so the write bit will still be cleared (expecting that the
next page fault will fill it up). However in step (5) we can't really
fill in the write bit since we'll fault again into the
handle_userfault() before that happens and then it goes back to step
(3) then it can actualy loop forever if without the loop detection
code in handle_userfault().

So I think now I understand that setting up the dirty bit in the
compound page should be enough, then would below change acceptable
instead?

diff --git a/mm/mprotect.c b/mm/mprotect.c
index 6d331620b9e5..0d4a8129a5e7 100644
--- a/mm/mprotect.c
+++ b/mm/mprotect.c
@@ -73,6 +73,7 @@ static unsigned long change_pte_range(struct vm_area_struct *vma, pmd_t *pmd,
if (pte_present(oldpte)) {
pte_t ptent;
bool preserve_write = prot_numa && pte_write(oldpte);
+ bool dirty;

/*
* Avoid trapping faults against the zero or KSM
@@ -115,8 +116,18 @@ static unsigned long change_pte_range(struct vm_area_struct *vma, pmd_t *pmd,
if (preserve_write)
ptent = pte_mk_savedwrite(ptent);

+ /*
+ * The extra PageDirty() check will make sure
+ * we'll capture the dirty page even if the
+ * PTE dirty bit unset. One case is when the
+ * PTE is splitted from a huge PMD, in that
+ * case the dirty flag might only be set on
+ * the compound page instead of this PTE.
+ */
+ dirty = pte_dirty(ptent) || PageDirty(pte_page(ptent));
+
/* Avoid taking write faults for known dirty pages */
- if (dirty_accountable && pte_dirty(ptent) &&
+ if (dirty_accountable && dirty &&
(pte_soft_dirty(ptent) ||
!(vma->vm_flags & VM_SOFTDIRTY))) {
ptent = pte_mkwrite(ptent);
I tested that this change can also fix my problem (QEMU will not get
SIGBUS after write protection starts).

Thanks,

--
Peter Xu

\
 
 \ /
  Last update: 2018-09-07 06:36    [W:0.067 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site