Messages in this thread Patch in this message | | | From | Kunihiko Hayashi <> | Subject | [PATCH 1/2] dt-bindings: phy: add UniPhier PCIe PHY description | Date | Wed, 5 Sep 2018 18:49:44 +0900 |
| |
Add DT bindings for PHY interface built into PCIe controller implemented in UniPhier SoCs.
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com> --- .../devicetree/bindings/phy/uniphier-pcie-phy.txt | 31 ++++++++++++++++++++++ 1 file changed, 31 insertions(+) create mode 100644 Documentation/devicetree/bindings/phy/uniphier-pcie-phy.txt
diff --git a/Documentation/devicetree/bindings/phy/uniphier-pcie-phy.txt b/Documentation/devicetree/bindings/phy/uniphier-pcie-phy.txt new file mode 100644 index 0000000..1889d3b --- /dev/null +++ b/Documentation/devicetree/bindings/phy/uniphier-pcie-phy.txt @@ -0,0 +1,31 @@ +Socionext UniPhier PCIe PHY bindings + +This describes the devicetree bindings for PHY interface built into +PCIe controller implemented on Socionext UniPhier SoCs. + +Required properties: +- compatible: Should contain one of the following: + "socionext,uniphier-ld20-pcie-phy" - for LD20 PHY + "socionext,uniphier-pxs3-pcie-phy" - for PXs3 PHY +- reg: Specifies offset and length of the register set for the device. +- #phy-cells: Must be zero. +- clocks: A phandle to the clock gate for PCIe glue layer including + this phy. +- resets: A phandle to the reset line for PCIe glue layer including + this phy. + +Optional properties: +- socionext,syscon: A phandle to system control to set configurations + for phy. + +Refer to phy/phy-bindings.txt for the generic PHY binding properties. + +Example: + pcie_phy: phy@66038000 { + compatible = "socionext,uniphier-ld20-pcie-phy"; + reg = <0x66038000 0x4000>; + #phy-cells = <0>; + clocks = <&sys_clk 24>; + resets = <&sys_rst 24>; + socionext,syscon = <&soc_glue>; + }; -- 2.7.4
| |