lkml.org 
[lkml]   [2018]   [Sep]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] ASoC: tlv320aic31xx: Add MICBIAS off setting
From
Date
On 09/04/2018 09:55 AM, Mark Brown wrote:
> On Tue, Sep 04, 2018 at 09:43:03AM -0500, Andrew F. Davis wrote:
>> On 09/04/2018 09:41 AM, Mark Brown wrote:
>
>>>>> If we really want to pay attention to something setting this up we'd
>>>>> need to completely remove the widget - what the code is doing at the
>>>>> minute is setting the voltage that the bias will go to when enabled,
>>>>> there's still a widget for turning it on and off. There's some chance
>>>>> that this will break existing boards.
>
>>>> Turning on bias is controlled separately, automatically in user-space in
>>>> many cases, not based on the board. The DT needs to have a way to state
>>>> that 0v is the needed bias on this board, without this you can not set
>>>> 0v bias and 2v is chosen by default (which is IMHO should be 0v but that
>>>> would change existing behavior so I won't touch that).
>
>>> Surely turning on MICBIAS at 0V is equivalent to leaving the bias off?
>
>> It is, but DT doesn't control when or why MICBIAS is turned on or off,
>> only what voltage on should be.
>
> The DT controls this in so far as it will arrange for the bias to be
> connected to something, if it's not connected to anything then it will
> only be turned on if the machine driver explicitly forces it on which is
> a potential source of problems but seems comfortably in "you broke it,
> you get to keep the pieces" territory. If we really want to have a way
> of explicitly specifying that some widgets should never be turned on
> then it feels like rather than have something device and widget specific
> like this we should instead have a higher level way of doing that which
> can be applied to any widget, that is something that could be useful
> especially with things like speaker drivers where there's real potential
> for physical damage to the system.
>


Not sure how that could even look, it would need to be in DT as only
that layer knows the connections, but then the it would also have to
have internal knowledge of the widgets used in the driver..


> Like I said in my original reply I'm also worried that this will break
> existing boards by causing them to change to a voltage of 0 when they
> had managed to end up with the default of 2V which happened to work for
> them.
>

Then only time this could happen is if they specified MICBIAS_OFF in DT
but got the default 2v instead. In which case, yes, the behavior would
change, but it would also be changing to the correct behavior. We can't
avoid fixing code on the off chance someone depended on the broken
behavior, no progress could ever be made.

\
 
 \ /
  Last update: 2018-09-04 17:10    [W:0.056 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site