lkml.org 
[lkml]   [2018]   [Sep]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: [PATCH v2 00/34] ARM: dts: tegra: apalis_t30: major revamp incl. v1.1 hardware support
    On Fri, Aug 31, 2018 at 06:37:42PM +0200, Marcel Ziswiler wrote:
    > This series is a major overhaul and adds support for the V1.1 hardware
    > revision of the Toradex Apalis T30 system on module.
    >
    > Changes in v2:
    > - Clean-up PCIe controller/port status' as well.
    > - Also move serial UART "nvidia,tegra30-hsuart" compatible to module
    > level device trees.
    > - Also add two missing newlines.
    > - Also replace underscores in node names with dashes.
    > - Explicitly disable input of BKL1_ON as well.
    > - Replace underscores in node names with dashes.
    > - When running some more tests I realized that the reg-addr should
    > really be 0x3f. Fix this.
    > - Get rid of fake clocks simple bus as suggested by Rob.
    > - Replace "[PATCH 27/28] ARM: tegra: apalis_t30: fix pcie switch vendor
    > compatible" with "[PATCH v2 26/34] dt-bindings: add broadcom (formerly
    > plx technology) vendor prefix" as suggested by Stefan.
    > - New patch as suggested by Rob.
    > - New patch.
    > - Drop "[PATCH 01/28] ARM: tegra: apalis_t30: enable broken-hpi on emmc"
    > which should already be handled by the broken-hpi quirk as pointed out
    > by Dmitry. If I would find more eMMC parts which exhibit the issue I
    > will add them to the quirk as a separate patch.
    > - Updated V1.1 device trees with all applicable previous fixes.
    >
    > Marcel Ziswiler (34):
    > ARM: tegra: apalis_t30: fix mmc1 cmd pull-up
    > ARM: tegra: apalis_t30: pull-up sd card detect pins
    > ARM: tegra: apalis_t30: add local-mac-address property
    > ARM: tegra: apalis_t30: reorder pcie properties
    > ARM: tegra: apalis_t30: annotate/clean-up pcie controller/port nodes
    > ARM: tegra: apalis_t30: reorder host1x/hdmi properties
    > ARM: tegra: apalis_t30: regulator clean-up
    > ARM: tegra: apalis_t30: add missing regulators
    > ARM: tegra: apalis_t30: annotate uarts and move compatible to board
    > ARM: tegra: apalis_t30: drop unused cami2c label
    > ARM: tegra: apalis_t30: white-space/newline clean-up
    > ARM: tegra: apalis_t30: drop unused mmc1/sd1 labels
    > ARM: tegra: apalis_t30: annotate mmc1/sd1
    > ARM: tegra: apalis_t30: move dr_mode property from phy to controller
    > ARM: tegra: apalis_t30: reorder backlight properties
    > ARM: tegra: apalis_t30: drop pwmleds
    > ARM: tegra: apalis_t30: pinmux clean-up
    > ARM: tegra: apalis_t30: add missing pinmux
    > ARM: tegra: apalis_t30: use proper irq-gpio for stmpe811
    > ARM: tegra: apalis_t30: further lm95245 temperature sensor annotation
    > ARM: tegra: apalis_t30: add i2c-thermtrip
    > ARM: tegra: apalis_t30: add proper emmc vmmc and vqmmc supplies
    > ARM: tegra: apalis_t30: enable emmc ddr52 mode
    > ARM: tegra: apalis_t30: get rid of fake clocks simple bus
    > ARM: tegra: apalis_t30: line break long compatible property line
    > dt-bindings: add broadcom (formerly plx technology) vendor prefix
    > ARM: tegra: apalis_t30: drop module level model and compatible
    > ARM: tegra: apalis_t30: drop obsolete spidev nodes
    > ARM: tegra: apalis_t30: hog group for pcie switch reset gpio
    > ARM: tegra: apalis_t30: rename hdmiddc to hdmi_ddc
    > ARM: tegra: apalis_t30: rename tps65911@2d, stmpe811@41 and
    > tps62362@60
    > ARM: tegra: apalis_t30: fix mcp2515 can controller interrupt polarity
    > ARM: tegra: apalis_t30: move hda node from carrier to module
    > ARM: tegra: apalis_t30: support v1.1 hardware revision
    >
    > Documentation/devicetree/bindings/arm/tegra.txt | 2 +
    > .../devicetree/bindings/vendor-prefixes.txt | 1 +
    > arch/arm/boot/dts/Makefile | 1 +
    > arch/arm/boot/dts/tegra30-apalis-eval.dts | 148 +--
    > arch/arm/boot/dts/tegra30-apalis-v1.1-eval.dts | 266 +++++
    > arch/arm/boot/dts/tegra30-apalis-v1.1.dtsi | 1189 ++++++++++++++++++++
    > arch/arm/boot/dts/tegra30-apalis.dtsi | 705 +++++++++---
    > 7 files changed, 2064 insertions(+), 248 deletions(-)
    > create mode 100644 arch/arm/boot/dts/tegra30-apalis-v1.1-eval.dts
    > create mode 100644 arch/arm/boot/dts/tegra30-apalis-v1.1.dtsi

    Applied, thanks.

    Thierry
    [unhandled content-type:application/pgp-signature]
    \
     
     \ /
      Last update: 2018-09-26 16:47    [W:4.118 / U:0.220 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site