lkml.org 
[lkml]   [2018]   [Sep]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 2/2] hwmon: ina3221: Read channel input source info from DT
From
Date
On 09/22/2018 08:33 PM, Nicolin Chen wrote:

>> No. If the chip was configured by the BIOS/ROMMON, it is supposed
>> to be that way. We can not just override that.
>
> For this driver, it does soft reset in the probe() so we're
> sure that all channels are enabled at the moment of calling
> this regmap_update_bits. So there's no assumption anymore.
>

Good point.

> But the case that you mentioned is a good one. It does give
> me some insight about the use case and the things that will
> need to be careful when adding in[123]_enable. Just it'd be
> also possible that BIOS could disable a channel that is not
> explicitly disabled in the DT -- then the driver should not
> enable it.
>

Not necessarily. Again, we can not assume that everyone has DT
(or that it and/or the BIOS is correct, for that matter).

Nevertheless, adding the enable attribute is not required at this
point, so it is ok for me to skip it. Please note that I'll accept
a patch adding it, though, if it is ever submitted (with a use case).

Thanks,
Guenter

\
 
 \ /
  Last update: 2018-09-23 07:26    [W:0.593 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site