Messages in this thread Patch in this message | | | From | Dilip Kota <> | Subject | [PATCH V4 1/4] dt-bindings: soc: qcom: Remove SPI controller maximum frequency binding | Date | Tue, 18 Sep 2018 23:37:23 +0530 |
| |
SPI controller driver should maintain the maximum frequency of the controller instead of relying on device tree bindings. Because maximum frequency is specific property of SPI controller.
Signed-off-by: Dilip Kota <dkota@codeaurora.org> --- Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 2 -- 1 file changed, 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt index 68b7d62..16467ed 100644 --- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt +++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt @@ -60,7 +60,6 @@ Required properties: - interrupts: Must contain SPI controller interrupts. - clock-names: Must contain "se". - clocks: Serial engine core clock needed by the device. -- spi-max-frequency: Specifies maximum SPI clock frequency, units - Hz. - #address-cells: Must be <1> to define a chip select address on the SPI bus. - #size-cells: Must be <0>. @@ -112,7 +111,6 @@ Example: pinctrl-names = "default", "sleep"; pinctrl-0 = <&qup_1_spi_2_active>; pinctrl-1 = <&qup_1_spi_2_sleep>; - spi-max-frequency = <19200000>; #address-cells = <1>; #size-cells = <0>; }; -- Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc. Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project.
| |