lkml.org 
[lkml]   [2018]   [Sep]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] cpufreq: intel_pstate: Optimize IO boost in non HWP mode
Date
"Rafael J. Wysocki" <rafael@kernel.org> writes:

> On Sat, Sep 15, 2018 at 8:53 AM Francisco Jerez <currojerez@riseup.net> wrote:
>>
>> "Rafael J. Wysocki" <rjw@rjwysocki.net> writes:
>>
>> > On Tuesday, September 11, 2018 7:35:15 PM CEST Francisco Jerez wrote:
>> >>
>> >> "Rafael J. Wysocki" <rjw@rjwysocki.net> writes:
>> >>
>> >> > On Thursday, September 6, 2018 6:20:08 AM CEST Francisco Jerez wrote:
>> >> >
>> >> >> Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com> writes:
>> >> >>=20
>> >> >> > [...]
>> >> >> >
>> >> >> >> > >=3D20
>> >> >> >> > > This patch causes a number of statistically significant
>> >> >> >> > > regressions
>> >> >> >> > > (with significance of 1%) on the two systems I've tested it
>> >> >> >> > > on. On
>> >> >> >> > > my
>> >> >> >> >=3D20
>> >> >> >> > Sure. These patches are targeted to Atom clients where some of
>> >> >> >> > these
>> >> >> >> > server like workload may have some minor regression on few watts
>> >> >> >> > TDP
>> >> >> >> > parts.
>> >> >> >>=3D20
>> >> >> >> Neither the 36% regression of fs-mark, the 21% regression of sqlite,
>> >> >> >> nor
>> >> >> >> the 10% regression of warsaw qualify as small. And most of the test
>> >> >> >> cases on the list of regressions aren't exclusively server-like, if
>> >> >> >> at
>> >> >> >> all. Warsaw, gtkperf, jxrendermark and lightsmark are all graphics
>> >> >> >> benchmarks -- Latency is as important if not more for interactive
>> >> >> >> workloads than it is for server workloads. In the case of a conflict
>> >> >> >> like the one we're dealing with right now between optimizing for
>> >> >> >> throughput (e.g. for the maximum number of requests per second) and
>> >> >> >> optimizing for latency (e.g. for the minimum request duration), you
>> >> >> >> are
>> >> >> >> more likely to be concerned about the former than about the latter in
>> >> >> >> a
>> >> >> >> server setup.
>> >> >> >
>> >> >> > Eero,
>> >> >> > Please add your test results here.
>> >> >> >
>> >> >> > No matter which algorithm you do, there will be variations. So you have
>> >> >> > to look at the platforms which you are targeting. For this platform=3D=
>> >> 20
>> >> >> > number one item is use of less turbo and hope you know why?
>> >> >>=20
>> >> >> Unfortunately the current controller uses turbo frequently on Atoms for
>> >> >> TDP-limited graphics workloads regardless of IOWAIT boosting. IOWAIT
>> >> >> boosting simply exacerbated the pre-existing energy efficiency problem.
>> >> >
>> >> > My current understanding of the issue at hand is that using IOWAIT boosti=
>> >> ng
>> >> > on Atoms is a regression relative to the previous behavior.
>> >>
>> >> Not universally. IOWAIT boosting helps under roughly the same
>> >> conditions on Atom as it does on big core, so applying this patch will
>> >> necessarily cause regressions too (see my reply from Sep. 3 for some
>> >> numbers), and won't completely restore the previous behavior since it
>> >> simply decreases the degree of IOWAIT boosting applied without being
>> >> able to avoid it (c.f. the series I'm working on that does something
>> >> similar to IOWAIT boosting when it's able to determine it's actually
>> >> CPU-bound, which prevents energy inefficient behavior for non-CPU-bound
>> >> workloads that don't benefit from a higher CPU clock frequency anyway).
>> >
>> > Well, OK. That doesn't seem to be a clear-cut regression situation, then,
>> > since getting back is not desirable, apparently.
>> >
>> > Or would it restore the previous behavior if we didn't do any IOWAIT
>> > boosting on Atoms at all?
>> >
>> >> > That is what Srinivas is trying to address here AFAICS.
>> >> >
>> >> > Now, you seem to be saying that the overall behavior is suboptimal and the
>> >> > IOWAIT boosting doesn't matter that much,
>> >>
>> >> I was just saying that IOWAIT boosting is less than half of the energy
>> >> efficiency problem, and this patch only partially addresses that half of
>> >> the problem.
>> >
>> > Well, fair enough, but there are two things to consider here, the general
>> > energy-efficiency problem and the difference made by IOWAIT boosting.
>> >
>> > If the general energy-efficiency problem had existed for a relatively long
>> > time, but it has got worse recently due to the IOWAIT boosting, it still
>> > may be desirable to get the IOWAIT boosting out of the picture first
>> > and then get to the general problem.
>> >
>>
>> IMHO what is needed in order to address the IOWAIT boosting energy
>> efficiency problem is roughly the same we need in order to address the
>> other energy efficiency problem: A mechanism along the lines of [1]
>> allowing us to determine whether the workload is IO-bound or not. In
>> the former case IOWAIT boosting won't be able to improve the performance
>> of the workload since the limiting factor is the IO throughput, so it
>> will only increase the energy usage, potentially exacerbating the
>> bottleneck if the IO device is an integrated GPU. In the latter case
>> where the CPU and IO devices being waited on are both underutilized it
>> makes sense to optimize for low latency more aggressively (certainly
>> more aggressively than this patch does) which will increase the
>> utilization of the IO devices until at least one IO device becomes a
>> bottleneck, at which point the throughput of the system becomes roughly
>> independent of the CPU frequency and we're back to the former case.
>>
>> [1] https://patchwork.kernel.org/patch/10312259/
>
> I remember your argumentation above from the previous posts and I'm
> not questioning it. I don't see much point in repeating arguments
> that have been given already.
>
> My question was whether or not there was a regression related
> specifically to adding the IOWAIT boosting mechanism that needed to be
> addressed separately. I gather from the discussion so far that this
> is not the case.
>

There possibly was some slight graphics performance regression when i915
started doing IO waits, but i915 didn't have support for any BXT+
devices back then, which are the ones most severely hurt by it, so it
probably didn't cause a significant drop in most available benchmark
numbers and went unnoticed.

Regardless of whether there was a regression, I don't see the need of
fixing the IOWAIT issue separately from the other energy efficiency
issues of the active mode governor, because they both admit a common
solution...

> Thanks,
> Rafael
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2018-09-17 23:43    [W:0.108 / U:0.412 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site