Messages in this thread | | | Date | Mon, 10 Sep 2018 08:48:58 +0800 | From | Shawn Guo <> | Subject | Re: [PATCH v2 1/2] ARM: dts: imx6: RDU2: Use new CODEC reset pin name |
| |
On Tue, Sep 04, 2018 at 09:20:17AM -0500, Andrew F. Davis wrote: > The correct DT property for specifying a GPIO used for reset > is "reset-gpios", the driver now accepts this name use this here. > > Signed-off-by: Andrew F. Davis <afd@ti.com> > --- > > Changes from v1: > - Remove "fix" from commit message > > arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi > index 7fff3717cf7c..a0f5cfda0055 100644 > --- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi > +++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi > @@ -384,7 +384,7 @@ > AVDD-supply = <®_3p3v>; > IOVDD-supply = <®_3p3v>; > DVDD-supply = <&vgen4_reg>; > - gpio-reset = <&gpio1 2 GPIO_ACTIVE_HIGH>; > + reset-gpios = <&gpio1 2 GPIO_ACTIVE_LOW>;
Is it intended to change the polarity?
Shawn
> }; > > accel@1c { > @@ -572,7 +572,7 @@ > AVDD-supply = <®_3p3v>; > IOVDD-supply = <®_3p3v>; > DVDD-supply = <&vgen4_reg>; > - gpio-reset = <&gpio1 0 GPIO_ACTIVE_HIGH>; > + reset-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; > }; > > touchscreen@20 { > -- > 2.18.0 >
| |