lkml.org 
[lkml]   [2018]   [Aug]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V7 7/9] mmc: sdhci: SDMA may use Auto-CMD23 in v4 mode
Date
When Host Version 4 Enable is set to 1, SDMA uses ADMA System Address
register (05Fh-058h) instead of using register (000h-004h) to indicate
its system address of data location. The register (000h-004h) is
re-assigned to 32-bit Block Count and Auto CMD23 argument, so then SDMA
may use Auto CMD23.

Signed-off-by: Chunyan Zhang <zhang.chunyan@linaro.org>
---
drivers/mmc/host/sdhci.c | 8 ++++++--
1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 62d843ac90..ac92e0f 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -3834,10 +3834,14 @@ int sdhci_setup_host(struct sdhci_host *host)
if (host->quirks & SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12)
host->flags |= SDHCI_AUTO_CMD12;

- /* Auto-CMD23 stuff only works in ADMA or PIO. */
+ /*
+ * For v3 mode, Auto-CMD23 stuff only works in ADMA or PIO;
+ * For v4 mode, SDMA may use Auto-CMD23 as well.
+ */
if ((host->version >= SDHCI_SPEC_300) &&
((host->flags & SDHCI_USE_ADMA) ||
- !(host->flags & SDHCI_USE_SDMA)) &&
+ (!host->v4_mode && !(host->flags & SDHCI_USE_SDMA)) ||
+ (host->v4_mode && (host->flags & SDHCI_USE_SDMA))) &&
!(host->quirks2 & SDHCI_QUIRK2_ACMD23_BROKEN)) {
host->flags |= SDHCI_AUTO_CMD23;
DBG("Auto-CMD23 available\n");
--
2.7.4
\
 
 \ /
  Last update: 2018-08-29 09:04    [W:0.110 / U:0.592 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site