[lkml]   [2018]   [Aug]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 1/2] media: docs-rst: Document memory-to-memory video decoder interface
Hi Tomasz,

On 08/08/2018 05:55 AM, Tomasz Figa wrote:
> On Tue, Aug 7, 2018 at 4:37 PM Hans Verkuil <> wrote:

>>>>>>> +7. If all the following conditions are met, the client may resume the
>>>>>>> + decoding instantly, by using :c:func:`VIDIOC_DECODER_CMD` with
>>>>>>> + ``V4L2_DEC_CMD_START`` command, as in case of resuming after the drain
>>>>>>> + sequence:
>>>>>>> +
>>>>>>> + * ``sizeimage`` of new format is less than or equal to the size of
>>>>>>> + currently allocated buffers,
>>>>>>> +
>>>>>>> + * the number of buffers currently allocated is greater than or equal to
>>>>>>> + the minimum number of buffers acquired in step 6.
>>>>>> You might want to mention that if there are insufficient buffers, then
>>>>>> VIDIOC_CREATE_BUFS can be used to add more buffers.
>>>>> This might be a bit tricky, since at least s5p-mfc and coda can only
>>>>> work on a fixed buffer set and one would need to fully reinitialize
>>>>> the decoding to add one more buffer, which would effectively be the
>>>>> full resolution change sequence, as below, just with REQBUFS(0),
>>>>> REQBUFS(N) replaced with CREATE_BUFS.
>>>> What happens today in those drivers if you try to call CREATE_BUFS?
>>> s5p-mfc doesn't set the .vidioc_create_bufs pointer in its
>>> v4l2_ioctl_ops, so I suppose that would be -ENOTTY?
>> Correct for s5p-mfc.
> As Philipp clarified, coda supports adding buffers on the fly. I
> briefly looked at venus and mtk-vcodec and they seem to use m2m
> implementation of CREATE_BUFS. Not sure if anyone tested that, though.
> So the only hardware I know for sure cannot support this is s5p-mfc.

In Venus case CREATE_BUFS is tested with Gstreamer.


 \ /
  Last update: 2018-08-21 13:30    [W:0.107 / U:2.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site