lkml.org 
[lkml]   [2018]   [Aug]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v6 2/2] rtc: omap: Cut down the shutdown time from 2 seconds to 1 sec
Date
Cut down the shutdown time from 2 seconds to 1 sec. In case of roll
over try again.

Signed-off-by: Keerthy <j-keerthy@ti.com>
---
drivers/rtc/rtc-omap.c | 25 +++++++++++++++----------
1 file changed, 15 insertions(+), 10 deletions(-)

diff --git a/drivers/rtc/rtc-omap.c b/drivers/rtc/rtc-omap.c
index 44ff4cc..320b4a5 100644
--- a/drivers/rtc/rtc-omap.c
+++ b/drivers/rtc/rtc-omap.c
@@ -421,12 +421,6 @@ static int omap_rtc_set_alarm(struct device *dev, struct rtc_wkalrm *alm)
* The RTC can be used to control an external PMIC via the pmic_power_en pin,
* which can be configured to transition to OFF on ALARM2 events.
*
- * Notes:
- * The two-second alarm offset is the shortest offset possible as the alarm
- * registers must be set before the next timer update and the offset
- * calculation is too heavy for everything to be done within a single access
- * period (~15 us).
- *
* Called with local interrupts disabled.
*/
static void omap_rtc_power_off(void)
@@ -434,6 +428,7 @@ static void omap_rtc_power_off(void)
struct omap_rtc *rtc = omap_rtc_power_off_rtc;
struct rtc_time tm;
unsigned long now;
+ int seconds;
u32 val;

rtc->type->unlock(rtc);
@@ -441,11 +436,13 @@ static void omap_rtc_power_off(void)
val = rtc_readl(rtc, OMAP_RTC_PMIC_REG);
rtc_writel(rtc, OMAP_RTC_PMIC_REG, val | OMAP_RTC_PMIC_POWER_EN_EN);

- /* set alarm two seconds from now */
+again:
+ /* set alarm one second from now */
omap_rtc_read_time_raw(rtc, &tm);
+ seconds = tm.tm_sec;
bcd2tm(&tm);
rtc_tm_to_time(&tm, &now);
- rtc_time_to_tm(now + 2, &tm);
+ rtc_time_to_tm(now + 1, &tm);

if (tm2bcd(&tm) < 0) {
dev_err(&rtc->rtc->dev, "power off failed\n");
@@ -470,14 +467,22 @@ static void omap_rtc_power_off(void)
val = rtc_read(rtc, OMAP_RTC_INTERRUPTS_REG);
rtc_writel(rtc, OMAP_RTC_INTERRUPTS_REG,
val | OMAP_RTC_INTERRUPTS_IT_ALARM2);
+
+ /* Retry in case roll over happened before alarm was armed. */
+ if (rtc_read(rtc, OMAP_RTC_SECONDS_REG) != seconds) {
+ val = rtc_read(rtc, OMAP_RTC_STATUS_REG);
+ if (!(val & OMAP_RTC_STATUS_ALARM2))
+ goto again;
+ }
+
rtc->type->lock(rtc);

/*
- * Wait for alarm to trigger (within two seconds) and external PMIC to
+ * Wait for alarm to trigger (within one second) and external PMIC to
* power off the system. Add a 500 ms margin for external latencies
* (e.g. debounce circuits).
*/
- mdelay(2500);
+ mdelay(1500);
}

static const struct rtc_class_ops omap_rtc_ops = {
--
1.9.1
\
 
 \ /
  Last update: 2018-08-16 07:10    [W:0.054 / U:0.292 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site