lkml.org 
[lkml]   [2018]   [Aug]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC PATCH 00/17] btrfs zoned block device support
From
Date
On 2018-08-14 03:41, Hannes Reinecke wrote:
> On 08/13/2018 09:29 PM, Austin S. Hemmelgarn wrote:
>> On 2018-08-13 15:20, Hannes Reinecke wrote:
>>> On 08/13/2018 08:42 PM, David Sterba wrote:
>>>> On Fri, Aug 10, 2018 at 03:04:33AM +0900, Naohiro Aota wrote:
>>>>> This series adds zoned block device support to btrfs.
>>>>
>>>> Yay, thanks!
>>>>
> [ .. ]
>>>> Device replace is disabled, but the changlog suggests there's a way to
>>>> make it work, so it's a matter of implementation. And this should be
>>>> implemented at the time of merge.
>>>>
>>> How would a device replace work in general?
>>> While I do understand that device replace is possible with RAID
>>> thingies, I somewhat fail to see how could do a device replacement
>>> without RAID functionality.
>>> Is it even possible?
>>> If so, how would it be different from a simple umount?
>> Device replace is implemented in largely the same manner as most other
>> live data migration tools (for example, LVM2's pvmove command).
>>
>> In short, when you issue a replace command for a given device, all
>> writes that would go to that device are instead sent to the new device.
>> While this is happening, old data is copied over from the old device to
>> the new one.  Once all the data is copied, the old device is released
>> (and it's BTRFS signature wiped), and the new device has it's device ID
>> updated to that of the old device.
>>
>> This is possible largely because of the COW infrastructure, but it's
>> implemented in a way that doesn't entirely depend on it (otherwise it
>> wouldn't work for NOCOW files).
>>
>> Handling this on zoned devices is not likely to be easy though, you
>> would functionally have to freeze I/O that would hit the device being
>> replaced so that you don't accidentally write to a sequential zone out
>> of order.
>
> Ah. Oh. Hmm.
>
> It would be possible in principle if we freeze accesses to any partially
> filled zones on the original device. Then all new writes will be going
> into new/empty zones on the new disks, and we can copy over the old data
> with no issue at all.
> We end up with some partially filled zones on the new disk, but they
> really should be cleaned up eventually either by the allocator filling
> up the partially filled zones or once garbage collection clears out
> stale zones.
>
> However, I fear the required changes to the btrfs allocator are beyond
> my btrfs knowledge :-(
The easy short term solution is to just disallow the replace command
(with the intent of getting it working in the future), but ensure that
the older style add/remove method works. That uses the balance code
internally, so it should honor any restrictions on block placement for
the new device, and therefore should be pretty easy to get working.

\
 
 \ /
  Last update: 2018-08-15 13:26    [W:0.091 / U:23.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site