lkml.org 
[lkml]   [2018]   [Jul]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 1/2] pinctrl: stm32: fix bank io port number
From
Date
Hi Rob

On 07/20/2018 06:35 PM, Rob Herring wrote:
> On Mon, Jul 16, 2018 at 02:57:36PM +0200, Alexandre Torgue wrote:
>> In case the exti line is not in line with the bank number (that is the case
>> when there is an hole between two banks, for example GPIOK and then GPIOZ),
>> use "st,bank-ioport" DT property to get the right exti line.
>>
>> Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
>> Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>
>>
>> diff --git a/Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt
>> index 9a06e1f..60c678a 100644
>> --- a/Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt
>> +++ b/Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt
>> @@ -55,6 +55,8 @@ Optional properties:
>> NOTE: If "gpio-ranges" is used for a gpio controller, all gpio-controller
>> have to use a "gpio-ranges" entry.
>> More details in Documentation/devicetree/bindings/gpio/gpio.txt.
>> + - st,bank-ioport: should correspond to the EXTI IOport selection (EXTI line
>> + used to select GPIOs as interrupts).
>
> ioport sounds like something else. Perhaps '-exti-line'?

IOport is actually what is described in our datasheet. I could change it
to -exti-line but I would prefer to match with the datasheet.

Regards
Alex
>
>>
>> Example 1:
>> #include <dt-bindings/pinctrl/stm32f429-pinfunc.h>

\
 
 \ /
  Last update: 2018-07-24 18:08    [W:0.064 / U:1.236 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site