Messages in this thread | | | Subject | Re: [PATCH v4 2/2] ARM: dts: am335x: add am335x-sancloud-bbe board support | From | Koen Kooi <> | Date | Tue, 17 Jul 2018 08:26:21 +0200 |
| |
> Op 17 jul. 2018, om 08:16 heeft Tony Lindgren <tony@atomide.com> het volgende geschreven: > > Hi Koen, > > Just noticed there should be generic node names here too, see below. > > * Koen Kooi <koen@dominion.thruhere.net> [180713 06:28]: >> The "Beaglebone Enhanced" by Sancloud is based on the Beaglebone Black, >> but with the following differences: >> >> * Gigabit capable PHY >> * Extra USB hub, optional i2c control >> * lps3331ap barometer connected over i2c >> * MPU6050 6 axis MEMS accelerometer/gyro connected over i2c >> * 1GiB DDR3 RAM >> * RTL8723 Wifi/Bluetooth connected over USB > >> +&i2c0 { >> + lps331ap: lps331ap@5C { >> + compatible = "st,lps331ap-press"; >> + st,drdy-int-pin = <1>; >> + reg = <0x5C>; >> + interrupt-parent = <&gpio1>; >> + interrupts = <26 IRQ_TYPE_EDGE_RISING>; >> + }; > > lps33lap: barometer@5c > >> + mpu6050: mpu6050@68 { >> + compatible = "invensense,mpu6050"; >> + reg = <0x68>; >> + interrupt-parent = <&gpio0>; >> + interrupts = <2 IRQ_TYPE_EDGE_RISING>; >> + orientation = <0xff 0 0 0 1 0 0 0 0xff>; >> + }; > > mpu6050: accelerometer@2c > > And so on. Please check the lower case hex numbers too as > that’s what Linux typically uses.
Thanks for the feedback! Fixed both issues, v5 sent out.
regards,
Koen
> > Thanks, > > Tony
| |