Messages in this thread | | | Subject | Re: [media] duplicate code in media drivers | From | "Gustavo A. R. Silva" <> | Date | Tue, 22 May 2018 12:11:26 -0500 |
| |
On 05/21/2018 03:44 PM, Devin Heitmueller wrote: >>> diff -u -p drivers/media/dvb-frontends/au8522_decoder.c /tmp/nothing/media/dvb-frontends/au8522_decoder.c >>> --- drivers/media/dvb-frontends/au8522_decoder.c >>> +++ /tmp/nothing/media/dvb-frontends/au8522_decoder.c >>> @@ -280,14 +280,9 @@ static void setup_decoder_defaults(struc >>> AU8522_TOREGAAGC_REG0E5H_CVBS); >>> au8522_writereg(state, AU8522_REG016H, AU8522_REG016H_CVBS); >>> >>> - if (is_svideo) { >>> /* Despite what the table says, for the HVR-950q we still need >>> to be in CVBS mode for the S-Video input (reason unknown). */ >>> /* filter_coef_type = 3; */ >>> - filter_coef_type = 5; >>> - } else { >>> - filter_coef_type = 5; >>> - } >> >> Better ask Devin about this (c/c). > > This was a case where the implementation didn't match the datasheet, > and it wasn't clear why the filter coefficients weren't working > properly. Essentially I should have labeled that as a TODO or FIXME > when I disabled the "right" value and forced it to always be five. It > was also likely that the filter coefficients would need to differ if > taking video over the IF interface as opposed to CVBS/S-video, which > is why I didn't want to get rid of the logic entirely. That said, the > only product I've ever seen with the tda18271 mated to the au8522 will > likely never be supported for analog video under Linux for unrelated > reasons. > > That said, it's worked "good enough" since I wrote the code nine years > ago, so if somebody wants to submit a patch to either get rid of the > if() statement or mark it as a FIXME that will likely never actually > get fixed, I wouldn't have an objection to either. >
Devin,
I've sent a patch based on your feedback.
Thanks! -- Gustavo
| |