lkml.org 
[lkml]   [2018]   [May]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] ath10k: transmit queued frames after waking queues
On 2018-05-22 14:15, Niklas Cassel wrote:
> On Mon, May 21, 2018 at 04:11:38PM -0700, Rajkumar Manoharan wrote:
>> On 2018-05-21 13:43, Niklas Cassel wrote:
>> > The following problem was observed when running iperf:
[...]
>>
>> Sorry for the late response. ath10k_mac_tx_push_pending is already
>> called
>> at the end of NAPI handler. Isn't that enough to process pending
>> frames?
>
> This is true for e.g. ATH10K_BUS_PCI and ATH10K_BUS_SNOC,
> but not for e.g. ATH10K_BUS_SDIO and ATH10K_BUS_USB.
>
> While there is some SDIO code merged in Kalle's tree already,
> this problem was found when merging
> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/?h=ath10k-pending-sdio-usb
> with Kalle's ath-next branch.
>
>>
>> Earlier we observed performance issues in calling push_pending from
>> each
>> tx completion. IMHO this change may introduce the same problem again.
>
> I prefer functional TX over performance issues,
> but I agree that it is unfortunate that SDIO doesn't use
> ath10k_htt_txrx_compl_task().
> Erik, is there a reason for this?
>
Thanks for details. Now I see your problem. In case of low latency
devices (PCI/SNOC/AHB),
all CE rings interrupts are serviced first and later consolidated data
processing done
from ath10k_htt_txrx_compl_task and then ath10k_mac_tx_push_pending is
called from NAPI Poll.

In case of high latency devices (USB/SDIO), each endpoints are serviced
and all tx/rx jobs
are completed from the same context. Hence no need of consolidated
processing.

> Perhaps it would be possible to call ath10k_mac_tx_push_pending()
> from the equivalent to ath10k_htt_txrx_compl_task(),
> but from SDIO's point of view.
>
> Another solution might be to change so that we only call
> ath10k_mac_tx_push_pending() from ath10k_txrx_tx_unref()
> if (htt->num_pending_tx == 0). That should decrease the number
> of calls to ath10k_mac_tx_push_pending(), while still avoiding
> a "TX deadlock" scenario for SDIO.
>
This issue is specific to HL devices. But your change is common which
will impact LL devices.
I would prefer to call ath10k_mac_tx_push_pending after processing all
received mbox/urb messages.
Export ath10k_mac_tx_push_pending API and call it from USB/SDIO irq
handler. Any thoughts?

-Rajkumar

\
 
 \ /
  Last update: 2018-05-23 00:17    [W:0.053 / U:0.840 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site