Messages in this thread | | | Date | Tue, 15 May 2018 11:47:36 -0600 | From | Lina Iyer <> | Subject | Re: [PATCH v8 04/10] drivers: qcom: rpmh: add RPMH helper functions |
| |
On Fri, May 11 2018 at 14:17 -0600, Doug Anderson wrote: >Hi, > >On Wed, May 9, 2018 at 10:01 AM, Lina Iyer <ilina@codeaurora.org> wrote: >> +int rpmh_write(const struct device *dev, enum rpmh_state state, >> + const struct tcs_cmd *cmd, u32 n) >> +{ >> + DECLARE_COMPLETION_ONSTACK(compl); >> + DEFINE_RPMH_MSG_ONSTACK(dev, state, &compl, rpm_msg); >> + int ret; >> + >> + if (!cmd || !n || n > MAX_RPMH_PAYLOAD) >> + return -EINVAL; >> + >> + memcpy(rpm_msg.cmd, cmd, n * sizeof(*cmd)); >> + rpm_msg.msg.num_cmds = n; >> + >> + ret = __rpmh_write(dev, state, &rpm_msg); >> + if (ret) >> + return ret; >> + >> + ret = wait_for_completion_timeout(&compl, RPMH_TIMEOUT_MS); > >IMO it's almost never a good idea to use wait_for_completion_timeout() >together with a completion that's declared on the stack. If you >somehow insist that this is a good idea then I need to see incredibly >clear and obvious code/comments that say why it's impossible that the >process might somehow try to signal the completion _after_ >RPMH_TIMEOUT_MS has expired. > >Specifically if the timeout happens but the process could still signal >a completion later then they will access random data on the stack of a >function that has already returned. This causes ridiculously >difficult-to-debug crashes. > > >NOTE: You've got timeout set to 10 seconds here. Is that really even >useful? IMO just call wait_for_completion() without a timeout. It's >much better to have a nice clean hang than a random stack corruption. > > The 10 sec timeout will guarantee that we will not get a response at all anymore for the request. Usually requests can be considered failed if there is no response in a few tens of microseconds. 10 sec is just an arbitarily large number.
The reason we use timeout is that once the timeout happens, we know we have failed, we could trigger a watchdog or crash the system. This is very important for our productization in debugging RPMH failures. A hang would not always trigger a watchdog and the failure would be silent and possibly fatal but hard to debug.
-- Lina
| |