lkml.org 
[lkml]   [2018]   [May]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 2/2] net: stmmac: dwmac-meson: extend phy mode setting
Hello Yixun,

On Sat, Apr 28, 2018 at 12:21 PM, Yixun Lan <yixun.lan@amlogic.com> wrote:
> In the Meson-AXG SoC, the phy mode setting of PRG_ETH0 in the glue layer
> is extended from bit[0] to bit[2:0].
> There is no problem if we configure it to the RGMII 1000M PHY mode,
> since the register setting is coincidentally compatible with previous one,
> but for the RMII 100M PHY mode, the configuration need to be changed to
> value - b100.
> This patch was verified with a RTL8201F 100M ethernet PHY.
>
> Signed-off-by: Yixun Lan <yixun.lan@amlogic.com>
> ---
> .../ethernet/stmicro/stmmac/dwmac-meson8b.c | 120 +++++++++++++++---
> 1 file changed, 104 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
> index 7cb794094a70..4ff231df7322 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
> @@ -18,6 +18,7 @@
> #include <linux/io.h>
> #include <linux/ioport.h>
> #include <linux/module.h>
> +#include <linux/of_device.h>
> #include <linux/of_net.h>
> #include <linux/mfd/syscon.h>
> #include <linux/platform_device.h>
> @@ -29,6 +30,10 @@
>
> #define PRG_ETH0_RGMII_MODE BIT(0)
>
> +#define PRG_ETH0_EXT_PHY_MODE_MASK GENMASK(2, 0)
> +#define PRG_ETH0_EXT_RGMII_MODE 1
> +#define PRG_ETH0_EXT_RMII_MODE 4
> +
> /* mux to choose between fclk_div2 (bit unset) and mpll2 (bit set) */
> #define PRG_ETH0_CLK_M250_SEL_SHIFT 4
> #define PRG_ETH0_CLK_M250_SEL_MASK GENMASK(4, 4)
> @@ -47,12 +52,20 @@
>
> #define MUX_CLK_NUM_PARENTS 2
>
> +struct meson8b_dwmac;
> +
> +struct meson8b_dwmac_data {
> + int (*set_phy_mode)(struct meson8b_dwmac *dwmac);
> +};
> +
> struct meson8b_dwmac {
> - struct device *dev;
> - void __iomem *regs;
> - phy_interface_t phy_mode;
> - struct clk *rgmii_tx_clk;
> - u32 tx_delay_ns;
> + struct device *dev;
> + void __iomem *regs;
> +
> + const struct meson8b_dwmac_data *data;
> + phy_interface_t phy_mode;
> + struct clk *rgmii_tx_clk;
> + u32 tx_delay_ns;
> };
>
> struct meson8b_dwmac_clk_configs {
> @@ -171,6 +184,59 @@ static int meson8b_init_rgmii_tx_clk(struct meson8b_dwmac *dwmac)
> return 0;
> }
>
> +static int meson8b_set_phy_mode(struct meson8b_dwmac *dwmac)
> +{
> + switch (dwmac->phy_mode) {
> + case PHY_INTERFACE_MODE_RGMII:
> + case PHY_INTERFACE_MODE_RGMII_RXID:
> + case PHY_INTERFACE_MODE_RGMII_ID:
> + case PHY_INTERFACE_MODE_RGMII_TXID:
> + /* enable RGMII mode */
> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
> + PRG_ETH0_RGMII_MODE,
> + PRG_ETH0_RGMII_MODE);
> + break;
> + case PHY_INTERFACE_MODE_RMII:
> + /* disable RGMII mode -> enables RMII mode */
> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
> + PRG_ETH0_RGMII_MODE, 0);
> + break;
> + default:
> + dev_err(dwmac->dev, "fail to set phy-mode %s\n",
> + phy_modes(dwmac->phy_mode));
> + return -EINVAL;
> + }
> +
> + return 0;
> +}
> +
> +static int meson_axg_set_phy_mode(struct meson8b_dwmac *dwmac)
> +{
> + switch (dwmac->phy_mode) {
> + case PHY_INTERFACE_MODE_RGMII:
> + case PHY_INTERFACE_MODE_RGMII_RXID:
> + case PHY_INTERFACE_MODE_RGMII_ID:
> + case PHY_INTERFACE_MODE_RGMII_TXID:
> + /* enable RGMII mode */
> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
> + PRG_ETH0_EXT_PHY_MODE_MASK,
> + PRG_ETH0_EXT_RGMII_MODE);
> + break;
> + case PHY_INTERFACE_MODE_RMII:
> + /* disable RGMII mode -> enables RMII mode */
if you have to re-send it for whatever reason:
maybe you could remove the comments from meson_axg_set_phy_mode. the
"older" register layout requires un-setting RGMII mode to enable RMII
mode. however, for AXG there seem to be two dedicated values (1 and 4)
for each mode

apart from that:
Acked-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>

> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
> + PRG_ETH0_EXT_PHY_MODE_MASK,
> + PRG_ETH0_EXT_RMII_MODE);
> + break;
> + default:
> + dev_err(dwmac->dev, "fail to set phy-mode %s\n",
> + phy_modes(dwmac->phy_mode));
> + return -EINVAL;
> + }
> +
> + return 0;
> +}
> +
> static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
> {
> int ret;
> @@ -188,10 +254,6 @@ static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
>
> case PHY_INTERFACE_MODE_RGMII_ID:
> case PHY_INTERFACE_MODE_RGMII_TXID:
> - /* enable RGMII mode */
> - meson8b_dwmac_mask_bits(dwmac, PRG_ETH0, PRG_ETH0_RGMII_MODE,
> - PRG_ETH0_RGMII_MODE);
> -
> /* only relevant for RMII mode -> disable in RGMII mode */
> meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
> PRG_ETH0_INVERTED_RMII_CLK, 0);
> @@ -224,10 +286,6 @@ static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
> break;
>
> case PHY_INTERFACE_MODE_RMII:
> - /* disable RGMII mode -> enables RMII mode */
> - meson8b_dwmac_mask_bits(dwmac, PRG_ETH0, PRG_ETH0_RGMII_MODE,
> - 0);
> -
> /* invert internal clk_rmii_i to generate 25/2.5 tx_rx_clk */
> meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
> PRG_ETH0_INVERTED_RMII_CLK,
> @@ -274,6 +332,11 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
> goto err_remove_config_dt;
> }
>
> + dwmac->data = (const struct meson8b_dwmac_data *)
> + of_device_get_match_data(&pdev->dev);
> + if (!dwmac->data)
> + return -EINVAL;
> +
> res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
> dwmac->regs = devm_ioremap_resource(&pdev->dev, res);
> if (IS_ERR(dwmac->regs)) {
> @@ -298,6 +361,10 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
> if (ret)
> goto err_remove_config_dt;
>
> + ret = dwmac->data->set_phy_mode(dwmac);
> + if (ret)
> + goto err_remove_config_dt;
> +
> ret = meson8b_init_prg_eth(dwmac);
> if (ret)
> goto err_remove_config_dt;
> @@ -316,10 +383,31 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
> return ret;
> }
>
> +static const struct meson8b_dwmac_data meson8b_dwmac_data = {
> + .set_phy_mode = meson8b_set_phy_mode,
> +};
> +
> +static const struct meson8b_dwmac_data meson_axg_dwmac_data = {
> + .set_phy_mode = meson_axg_set_phy_mode,
> +};
> +
> static const struct of_device_id meson8b_dwmac_match[] = {
> - { .compatible = "amlogic,meson8b-dwmac" },
> - { .compatible = "amlogic,meson8m2-dwmac" },
> - { .compatible = "amlogic,meson-gxbb-dwmac" },
> + {
> + .compatible = "amlogic,meson8b-dwmac",
> + .data = &meson8b_dwmac_data,
> + },
> + {
> + .compatible = "amlogic,meson8m2-dwmac",
> + .data = &meson8b_dwmac_data,
> + },
> + {
> + .compatible = "amlogic,meson-gxbb-dwmac",
> + .data = &meson8b_dwmac_data,
> + },
> + {
> + .compatible = "amlogic,meson-axg-dwmac",
> + .data = &meson_axg_dwmac_data,
> + },
> { }
> };
> MODULE_DEVICE_TABLE(of, meson8b_dwmac_match);
> --
> 2.17.0
>

\
 
 \ /
  Last update: 2018-05-01 15:21    [W:0.114 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site