lkml.org 
[lkml]   [2018]   [Apr]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ata: ahci-platform: add reset control support
On Fri, Mar 23, 2018 at 10:30:53AM +0900, Kunihiko Hayashi wrote:
> Add support to get and control a list of resets for the device
> as optional and shared. These resets must be kept de-asserted until
> the device is enabled.
>
> This is specified as shared because some SoCs like UniPhier series
> have common reset controls with all ahci controller instances.
>
> Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
> ---
> .../devicetree/bindings/ata/ahci-platform.txt | 1 +
> drivers/ata/ahci.h | 1 +
> drivers/ata/libahci_platform.c | 24 +++++++++++++++++++---
> 3 files changed, 23 insertions(+), 3 deletions(-)

This causes a regression on Tegra because we explicitly request the
resets after the call to ahci_platform_get_resources().

From a quick look, ahci_mtk and ahci_st are in the same boat, adding the
corresponding maintainers to Cc.

Patrice, Matthias: does SATA still work for you after this patch? This
has been in linux-next since next-20180327.

Given how this is one of the more hardware-specific bits, perhaps a
better way to do this is to move reset handling into a Uniphier driver
much like Tegra, Mediatek and ST?

That said, I don't see SATA support for any of the Socionext hardware
either in the DT bindings or drivers/ata, so perhaps it'd be best to
back this out again until we have something that's more well tested?

Thierry
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2018-04-05 11:55    [W:0.089 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site