lkml.org 
[lkml]   [2018]   [Apr]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V4 3/6] ARM: dts: imx6sx-sabreauto: add IO expander max7310 support
On Thu, Apr 26, 2018 at 3:31 AM, Anson Huang <anson.huang@nxp.com> wrote:

> I searched the mail I sent, I can NOT found where I said "MAX7310 controls the ethernet phy"....

Initially you passed: pinctrl-assert-gpios = <&max7322 0
GPIO_ACTIVE_HIGH> inside the fec1 node.

Then I explained that 'pinctrl-assert-gpios' is not a valid property
in mainline. It only exists in NXP vendor tree.

Then you explained:

"Sorry, I made a mistake here, the MAX7320 IO0 is for adjusting FEC1's voltage"

> There are MAX7310 users, it is just because currently those users are NOT enabled, so I can
> NOT verify them. MAX7310 is an independent I2C device, why we can NOT enable it first?
> I tested it from sysfs interface, we can control the MAX7310's IO output via echo different value
> to GPIO value, that means MAX7310 itself as an IO expander chip is working just fine, similar with PMIC,
> it is a I2C device, can be enabled independently, then consumers can be added later when they are enabled.
> Just my personal opinion, thanks.

Right, but if FEC needs max7322 IO0 at level 1 then better describe it in dts.

\
 
 \ /
  Last update: 2018-04-26 19:24    [W:0.061 / U:0.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site