lkml.org 
[lkml]   [2018]   [Apr]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 2/2] usb: dwc2: fix isoc split in transfer with no data
From
Date
Hello!

On 4/24/2018 5:43 AM, William Wu wrote:

> If isoc split in transfer with no data (the length of DATA0
> packet is 0), we can't simply return immediately. Because the
> DATA0 can be the first transaction or the second transaction for
> the isoc split in transaction. If the DATA0 packet with on data
^^ no?

> is in the first transaction, we can return immediately. But if
> the the DATA0 packet with on data is in the second transaction

One "the" too many. And that "on data" again... :-)

> of isoc split in transaction sequence, we need to increase the
> qtd->isoc_frame_index and giveback urb to device driver if needed,
> otherwise, the MDATA packet will be lost.
>
> A typical test case is that connect the dwc2 controller with an
> usb hs Hub (GL852G-12), and plug an usb fs audio device (Plantronics
> headset) into the downstream port of Hub. Then use the usb mic
> to record, we can find noise when playback.
>
> In the case, the isoc split in transaction sequence like this:
>
> - SSPLIT IN transaction
> - CSPLIT IN transaction
> - MDATA packet (176 bytes)
> - CSPLIT IN transaction
> - DATA0 packet (0 byte)
>
> This patch use both the length of DATA0 and qtd->isoc_split_offset
> to check if the DATA0 is in the second transaction.
>
> Signed-off-by: William Wu <william.wu@rock-chips.com>
[...]

MBR, Sergei

\
 
 \ /
  Last update: 2018-04-24 10:28    [W:0.036 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site