lkml.org 
[lkml]   [2018]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] net: phy: marvell: clear wol event before setting it
On Thu, Apr 19, 2018 at 04:02:32PM +0800, Jisheng Zhang wrote:
> From: Jingju Hou <Jingju.Hou@synaptics.com>
>
> If WOL event happened once, the LED[2] interrupt pin will not be
> cleared unless reading the CSISR register. So clear the WOL event
> before enabling it.
>
> Signed-off-by: Jingju Hou <Jingju.Hou@synaptics.com>
> Signed-off-by: Jisheng Zhang <Jisheng.Zhang@synaptics.com>
> ---
> drivers/net/phy/marvell.c | 9 +++++++++
> 1 file changed, 9 insertions(+)
>
> diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
> index c22e8e383247..b6abe1cbc84b 100644
> --- a/drivers/net/phy/marvell.c
> +++ b/drivers/net/phy/marvell.c
> @@ -115,6 +115,9 @@
> /* WOL Event Interrupt Enable */
> #define MII_88E1318S_PHY_CSIER_WOL_EIE BIT(7)
>
> +/* Copper Specific Interrupt Status Register */
> +#define MII_88E1318S_PHY_CSISR 0x13
> +
> /* LED Timer Control Register */
> #define MII_88E1318S_PHY_LED_TCR 0x12
> #define MII_88E1318S_PHY_LED_TCR_FORCE_INT BIT(15)
> @@ -1393,6 +1396,12 @@ static int m88e1318_set_wol(struct phy_device *phydev,
> if (err < 0)
> goto error;
>
> + /* If WOL event happened once, the LED[2] interrupt pin
> + * will not be cleared unless reading the CSISR register.
> + * So clear the WOL event first before enabling it.
> + */
> + phy_read(phydev, MII_88E1318S_PHY_CSISR);
> +

Hi Jisheng

The problem with this is, you could be clearing a real interrupt, link
down/up etc. If interrupts are in use, i think the normal interrupt
handling will clear the WOL interrupt? So can you make this read
conditional on !phy_interrupt_is_valid()?

Andrew

\
 
 \ /
  Last update: 2018-04-19 14:18    [W:0.120 / U:0.820 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site