lkml.org 
[lkml]   [2018]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v8 1/2] dt-bindings: display: bridge: Document THC63LVD1024 LVDS decoder
From
Date
Hi Jacopo,

On 04/19/2018 12:44 PM, Vladimir Zapolskiy wrote:
> Hi Jacopo, Laurent,
>
> On 04/10/2018 01:53 PM, Jacopo Mondi wrote:
>> Document Thine THC63LVD1024 LVDS decoder device tree bindings.
>>
>> Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
>> Reviewed-by: Andrzej Hajda <a.hajda@samsung.com>
>> Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
>> Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
>
> Reviewed-by: Vladimir Zapolskiy <vladimir_zapolskiy@mentor.com>
>
>> ---
>> .../bindings/display/bridge/thine,thc63lvd1024.txt | 60 ++++++++++++++++++++++
>> 1 file changed, 60 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
>>
>> diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
>> new file mode 100644
>> index 0000000..0b23e70
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
>> @@ -0,0 +1,60 @@
>> +Thine Electronics THC63LVD1024 LVDS decoder
>> +-------------------------------------------
>> +
>> +The THC63LVD1024 is a dual link LVDS receiver designed to convert LVDS streams
>> +to parallel data outputs. The chip supports single/dual input/output modes,
>> +handling up to two LVDS input streams and up to two digital CMOS/TTL outputs.
>> +
>> +Single or dual operation mode, output data mapping and DDR output modes are
>> +configured through input signals and the chip does not expose any control bus.
>> +
>> +Required properties:
>> +- compatible: Shall be "thine,thc63lvd1024"
>> +- vcc-supply: Power supply for TTL output, TTL CLOCKOUT signal, LVDS input,
>> + PPL and digital circuitry
>> +
>> +Optional properties:
>> +- powerdown-gpios: Power down GPIO signal, pin name "/PDWN". Active low
>

sorry for a follow-up, I've just noticed it, could you please double check
spelling PDWN vs PWDN? Thank you in advance.

--
With best wishes,
Vladimir

\
 
 \ /
  Last update: 2018-04-19 11:49    [W:0.638 / U:0.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site