[lkml]   [2018]   [Apr]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 1/2] MIPS: BCM47XX: Add support for Netgear WNR1000 V3
On Sun, Apr 08, 2018 at 10:57:32PM +0200, Rafał Miłecki wrote:
> From: Rafał Miłecki <>
> This adds support for detecting this model board and registers some LEDs
> and buttons.
> There are two uncommon things regarding this device:
> 1) It can use two different "board_id" ID values.
> Unit I have uses "U12H139T00_NETGEAR" value. This magic is also used
> in firmware file header. There are two reports (one from an OpenWrt
> user) of a different "U12H139T50_NETGEAR" magic though.
> 2) Power LEDs share GPIOs with buttons.
> Amber one seems to share GPIO 2 with WPS button and green one seems
> to share GPIO 3 with reset button. It remains unknown how to support
> them and handle buttons at the same time. For that reason they aren't
> added to the list of supported LEDs.
> Signed-off-by: Rafał Miłecki <>

Thanks, both applied for 4.18.

[unhandled content-type:application/pgp-signature]
 \ /
  Last update: 2018-04-18 23:24    [W:0.061 / U:20.388 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site