lkml.org 
[lkml]   [2018]   [Apr]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] serial: imx: warn user when using unsupported configuration
On 18.04.2018 16:53, Uwe Kleine-König wrote:
> On Wed, Apr 18, 2018 at 04:06:38PM +0200, Stefan Agner wrote:
>> When using half-duplex mode (which disables receiver during txing)
>> the RTS signal cannot be driven low during transmission. This seems
>> to be a limitation of the i.MX UART IP: The RTS (CTS_B) signal is
>> controlled by the receiver. When the receiver is disabled, the
>> signal stays in UART logic idle state which is high...
>>
>> If SER_RS485_RTS_ON_SEND is used, RTS needs to be high active during
>> transmission. Since this is the default state of the RTS (CTS_B)
>> signal when the receiver is off, half-duplex mode in this
>> configuration works fine.
>>
>> However, a low-active RTS signal (flag SER_RS485_RTS_ON_SEND not set)
>> cannot be generated when the receiver is turned off.
>>
>> Print an error if the user selects this unsupported configuration
>> (both SER_RS485_RTS_ON_SEND and SER_RS485_RX_DURING_TX unset) and
>> configure the closest working configuration (set the
>> SER_RS485_RX_DURING_TX flag).
>>
>> Signed-off-by: Stefan Agner <stefan@agner.ch>
>> ---
>> Changes since v1:
>> - Consistently check for sport->have_rtscts && !(rs485conf->flags &
>> SER_RS485_RTS_ON_SEND)
>> - Don't break printed message
>>
>> drivers/tty/serial/imx.c | 15 +++++++++++++++
>> 1 file changed, 15 insertions(+)
>>
>> diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
>> index 91f3a1a5cb7f..1c1080fc8084 100644
>> --- a/drivers/tty/serial/imx.c
>> +++ b/drivers/tty/serial/imx.c
>> @@ -1833,6 +1833,11 @@ static int imx_uart_rs485_config(struct uart_port *port,
>> rs485conf->flags &= ~SER_RS485_ENABLED;
>>
>> if (rs485conf->flags & SER_RS485_ENABLED) {
>> + /* Enable receiver if low-active RTS signal is requested */
>> + if (sport->have_rtscts &&
>> + !(rs485conf->flags & SER_RS485_RTS_ON_SEND))
>> + rs485conf->flags |= SER_RS485_RX_DURING_TX;
>> +
>
> I wonder what should happen, if the device tree has both
>
> uart-has-rtscts;
> rts-gpios = <...>;

Hm, it seems that the code controls both in that case.

>
> . I think the right thing would be to check for
>
> sport->have_rtscts && !sport->have_rtsgpio

I agree, since it controls both one can use the GPIO to have a working
half duplex with low-active RTS configuration.

Will send v3.

--
Stefan

\
 
 \ /
  Last update: 2018-04-18 17:31    [W:0.044 / U:1.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site