[lkml]   [2018]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v13 0/6] Address error and recovery for AER and DPC
On Mon, Apr 09, 2018 at 10:41:48AM -0400, Oza Pawandeep wrote:
> This patch set brings in error handling support for DPC
> The current implementation of AER and error message broadcasting to the
> EP driver is tightly coupled and limited to AER service driver.
> It is important to factor out broadcasting and other link handling
> callbacks. So that not only when AER gets triggered, but also when DPC get
> triggered (for e.g. ERR_FATAL), callbacks are handled appropriately.
> DPC should behave identical to AER as far as error handling is concerned.
> DPC should remove the devices and not to do recovery for hotplug enabled system.

Is there a specific bug that's fixed by these patches? I didn't see
one mentioned in the changelogs.

 \ /
  Last update: 2018-04-16 05:17    [W:0.105 / U:4.552 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site